539639
32
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
36
E
6
To clean hard surfaces wooden oors, plastic oors,
ceramic tiles etc. pull out the brush by pressing the switch on
the combination brush according to the gure .
7
Pull the plug and cord (6) out of the vacuum cleaner.
ATTENTION! While pulling out the cord, pay attention
to the yellow stripe which signals the end of the
cord. Further attempts (pulling on cord) may result in
damaging the cord.
8
Plug in the appliance.
Before operation make sure that the SAFBAG bag is installed
in the vacuum cleaner chamber and that inlet lter and the
outlet lter is installed in the appliance.
9
Switch on the vacuum cleaner by pressing the “on/off”
button (1).
10
The vacuum cleaner is equipped with an electronic
suction power controller. The power adjustment is done by
means of a slider. By shirting the slider in a given direction,
you decrease or increase suction.
Filter disassembly
Before changing the lters make sure that the vacuum
cleaner is switched off and unplugged from the mains
supply.
INLET FILTER
1
Open the front cover handle (9).
2
Pull the bag out of the chamber (see p. E).
3
Remove the inlet lter (11) out of the housing.
4
If the inlet lter (11) is dirty, it may be rinsed with running
water. Remember to dry the lter, before its reinstallation.
ATTENTION! Due to safety reasons, it is vital never to
install a damp inlet lter (11).
5
Install a new/the rinsed inlet lter (11), making sure that
the whole lter is in the socket.
6
Insert a bag into the vacuum cleaner chamber (see
p. E).
7
Close the front cover of the vacuum cleaner.
ATTENTION! The damaged inlet lter should be replaced
with a new, genuine manufactured product only.
“MICROFILTER” OUTLET FILTER
1
Press the fastening on the outlet lter cover, then pull it
out of the vacuum cleaner.
2
Remove the microlter by unhooking it from the 4
fastenenings.
3
If the outlet lter (12) is dirty, it may be rinsed with running
water. Remember to dry the lter, before its reinstallation.
ATTENTION! Due to safety reasons, it is vital never to
install a damp outlet lter.
4
Install a new/the rinsed lter on the 4 fastenings.
Install the cover in such a way that the two protrusions
on the bottom part of the cover are put in the holes of
the housing, then press the lter cover to make the back
fastening clanged on the casing.
ATTENTION! Always replace a damaged inlet lter only
with a brand new one.
Dust bag disassembly/assembly
The XS vacuum cleaner is equipped with both two paper
bags and a single reusable bag.
1
Total covering up of bag loading indicator by the red
cover in case the sucker or the brush is upraised over
the cleaned surface informs, that change of dust bag is
necessary. The bag loading indicator may operate in case
of suction hose stopping or in case of stopping of equipment
elements connected thereto.
2
Switch off the vacuum cleaner by pressing the on/off
button (1).
3
Unplug the appliance.
4
Open the front cover handle (9).
5
Press the side button on the end of the hose, then remove
the end of the hose from the inlet hole of the vacuum cleaner.
6
Release the bag fastening according to the arrow on it
and then pull the bag up to remove it. Throw the bag out.
7
Replace the full bag with a new one the direction of
installing the bag is marked by an arrow on the bag plate.
ATTENTION! Carefully place the bag in such a way that
the hole in the bag plate was placed over the rubber
collar in the chamber of the vacuum cleaner.
8
Close the cover until you hear the characteristic clicking
sound – be careful not to catch the bag.
In case of using a reusable bag:
9
Release the bag fastening according to the arrow on it
and then pull the bag up to remove it.
10
Slid the closing board on the back part of the bag down
and empty out the contents.
ATTENTION! If the bag is very dirt, you can wash it in
water with a little amount of washing agent.
ATTENTION! If the bag was washed, it should be dried
before it is used again
11
Place the closing board on the back part of the emptied
bag.
12
Slid the bag into its place.
ATTENTION! Carefully place the bag in such a way that
the hole in the bag plate was placed over the rubber
collar in the chamber of the vacuum cleaner.
C
D
32

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zelmer 01z011 XS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zelmer 01z011 XS in de taal/talen: Engels, Pools als bijlage per email.

De handleiding is 3,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info