483706
7
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
The normal installation is like the above
Condition 1: Powering the Antenna by STB or Digital TV
Step 1.Take out the main unit AS 07
Step 2.Take out the multi-directional base. Fixed it on the wooden pole or at a wall (as figure, please
check the follow paragraph for information)
Step 3.fix the main unit to the multi-directional base
Step 4.Take the Coaxial(IEC male to F female) Cable connect the IEC Male end to the IEC Female
End of your Set Top Box or TV Set and F female the F-Female End of the AS 07.
Please note: all the connection should be fixed. It is recommended that you should had a
water-drop loop at the end of cable before entering your home.)
Step 5Adjust the orientation of AS 07. (Normally speaking, the signal is horizontal direction.)
Condition 2: Powering the antenna by AC adaptor( in cases that there is no DC
power out from the STB or Digital TV, you need to do this installation)
Tips for correct Antenna Adjustment
When you finished the installation, you can use your Set Top Box to check the signal strength
and quality. If the quality is not good enough to have good picture, you can move the antenna
to get the best reception position, when you find the best position , please fixed it. If not, you
can change the reception direction by adjust the main unit
Indoor /Outdoor Wall Mounted installation
If you want to hook this unit onto a brick wall or RC
wall, please follow the steps bellow
Before the following step, please make sure that you
have enough protection when you try to drill on the
wall.
Step 1. Mark the fixing position with pencil or another
pen( please use the multi-directional base to
mark the position)
Step 2.Take the electric drill, using 5.8mm drill bit( please note , when you use the electric drill, you
should better to wear the protection device. And the drill bit should be fixed, otherwise there
will be a serious injuring happened when the bit is broken or loose). Drill the depth to 35mm.
Then clean the hole.
Please note , if you want to install On a wooden wall , you don´t need to drill holes
before!
Step 3.Take out the plastic pole, using hammer to ham it into the hole made by step1
Step 4.Take out the screws attached, using screw driver to fix these screws through the base and fix it
on the wall.
Step 5. Fix the main unit on the multi-directional base
Step 6.Take the Coaxial(IEC male to IEC female) Cable connect the IEC Male end to the IEC Female
End of your Set Top Box or TV Set and IEC female to “Receiver” on power inserter. Take
another coaxial (F male to IEC male) cable, connect the F-male End to the F-Female End of the
AS 07 and IEC male to “Antenna” on Power inserter. Please note: all the connection should be
fixed. It is recommended that you should had a water-drop loop at the end of cable before
entering your home. (if your installation is outdoor)
Step 7.Take out the AC-DC Adaptor, connect the barrel end to the DC input of Power inserter, AC end
to the AC Outlet. Please note use only supplied AC adaptor
Step 8.Adjust the orientation of AS 07. (Normally speaking, the signal is horizontal direction.)
3
Final
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zehnder AS 07 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zehnder AS 07 in de taal/talen: Duits als bijlage per email.

De handleiding is 0,94 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info