44
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in origi-
nal packaging, in vertical position considering the
protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy con-
sumption and proper operation of the appliance. When
placing, take into consideration that it is practical to oper-
ate the appliance between ambient temperature limits
according to the climate class that is given in the chart
below and can be found in the data label.
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
increasing temperature in the cooling compartment or
increasing energy consumption.
When placing the appliance ensure that it stands level.
Class of climate
SN
N
ST
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
Mount the spacers supplied in the plastic bag of the
accessories. Hold the spacer as shown on the Fig.,
using fine strokes of hammer put it in its place.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appliance
has to be stood near a cooker take these minimum dis-
tances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5-1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
GB
