BEFORE MAKING CONNECTIONS, MAKE SURE THAT
THE AMPLIFIER IS SWITCHED OFF.
■ CONNECTIONS
● Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifi-
er with the provided speaker cords.
● One side of the speaker cord has a gray line. Connect
the (+) terminals on both the amplifier and the speakers
using the side of the cord with the gray line. Connect the
(–) terminals on both components using the side without
a gray line.
● Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity (+,
–). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
Procedures:
➀ Loosen the terminal knob.
➁ Insert the bare speaker wire end properly into the ter-
minal hole. [Remove approx. 10 mm (3/8”) insulation
from the speaker cord.]
➂ Tighten the knob.
➃ Test the security of the connection by pulling lightly the
cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or
the amplifier, or both of them.
SPECIFICATIONS
Type..........................2-way 2-speaker acoustic-suspension
speaker system
Speaker Unit..........................................10 cm cone woofer
2.2 cm dome tweeter
Input Terminal.....................................................Screw-type
Impedance .................................................................6 ohm
Frequency Response ..................................80 Hz – 30 kHz
Nominal Input Power.....................................................50W
Maximum Input Power ................................................150W
Sensitivity (2.83V, 1m) ................................................90 dB
Crossover Frequency..................................................5 kHz
Dimensions (WxHxD).......................150 x 265 x 156.3 mm
(5-7/8” x 10-7/16” x 6-3/16”)
Weight .................................................2.2 kg (4 lbs. 13 oz.)
Accessories ..................................Speaker cords (10m) x 2
* Specifications subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power val-
ues noted above.
CONNECTION TO YOUR AMPLIFIER
Red (+)
Black (–)
Speaker output
terminals of the
amplifier
Loosen
Tighten
Gray line
Amplifier
Gray line Gray line
Speaker (R)
Speaker (L)
