674747
35
Verklein
Vergroot
Pagina terug
1/140
Pagina verder
Page 33FT
DX
1200 OPERATING MANUAL
momentary presses of the
[
14
]
0H] band button.
(ach $mateur band button may similarly have up
to three freTuencymode settings applied.
When the
[
MHz/μT
]
button located to the left of
the
[
VFO-B/CLAR
]
knob) is pressed, the “
MHz
notation will appear in the display, and then rota-
tion of the
[
VFO-B/CLAR
]
knob will change the
freTuency in 1 0H] steps.
6. 3ress the
[
ANT
]
button to select the ap-
propriate antenna for the band in use.
A
DVICE:
When you make an antenna selection,
that antenna is “remembered” by the
microprocessor in conjunction with the
VF2 register in use.
7. 3ress the
[
MODE
]
button to select the
desired operating mode.
5epeated presses of the
[
MODE
]
button step through the available se-
lections.
3ressing and holding the
[
MODE
]
button will toggle to the alternate
mode.
For example, In the LSB or USB modes, pressing
and holding the
[
MODE
]
button toggles between
“LSB” and “USB” mode.
A
DVICE:
By convention in the $mateur bands, LSB is
used on the 7 0H] and lower bands with the
exception of 60 meters), while USB is utili]ed on
the 14 0H] and higher bands.
When changing modes from SSB to CW, you
will observe a freTuency shift on the display.
This shift represents the BF2 offset between the
]ero beat” freTuency and the audible CW pitch
tone) you can hear the pitch is programmed via
the 0enu item “
066 CW FREQ DISPLAY
”), even
1. Turn on the external 'C power supply.
. 3ress and hold in the front-panel
[
ON/OFF
]
switch
until the transceiver turns on. $fter
about five seconds ten seconds if the
optional -Tuning .it is connected), the
transceiver is ready for full operation.
3. The transceiver will start up on 7.000.000 0H]
LSB, or the previously used operating freTuency)
and normal operation may begin.
N
OTE:
To turn power off, press and hold in the front panel
[
ON/OFF
]
switch for one second.
4. 5otate the
[
AF
]
knob to set a com-
fortable audio level of the incoming
signals or noise. Clockwise rotation
of the
[
AF
]
knob increases the vol-
ume level.
N
OTE:
When using headphones, start by rotating the
[
AF
]
knob counter-clockwise, then bring the volume level
up after you put the headphones on. This will mini-
mi]e the chance of damage to your hearing caused
by an unexpectedly high audio level.
. 3ress an appropriate
[
BAND
]
key corresponding to
the $mateur band on which you wish to begin opera-
tion.
A
DVICE:
2ne-touch selection of each
$mateur band between 1.8
and 0 0H] is provided.
The
FT
DX
1200
utili]es a triple band-stack VF2
selection techniTue, which permits storing up to
three favorite freTuencies and modes onto each
VF2 band register. For example, you may store
one freTuency each on 14 0H] CW, 5TTY, and
USB, then recall these freTuencies by successive,
Here is the typical start-up procedure for normal operation
[
POWER
]
Switch
[
AF
]
Knob
Main Tuning Dial Knob
[
BAND
]
Keys
BASIC OPERATION:
RECEIVING ON AMATEUR BANDS
[
MODE
]
Button
[
ANT
]
Switch
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FTDX1200 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FTDX1200 in de taal/talen: Engels als bijlage per email.

De handleiding is 14,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info