478499
97
Verklein
Vergroot
Pagina terug
1/132
Pagina verder
95FT-857D Operating Manual
MENU OPERATION
Function
Selects the device which is connected to the CAT/
LINEAR jack on the rear panel.
Defines the “control” knob to be used for setting of
the clarifier offset frequency.
Selects whether the KEY jack shall be “Enabled” or
“Disabled” while using the SSB/FM modes.
Sets the CW carrier oscillator injection side on the
CW mode.
Sets the receiver recovery time during pseudo-
VOX CW semi-break-in operation.
Sets the keyer paddle’s wiring configuration.
Enables/disables CW keying by the microphone’s
[
UP
]
/
[
DWN
]
keys.
Setting of the pitch of the CW sidetone, BFO offset,
and CW filter center frequencies.
Selects the time delay between when the PTT is
keyed and the carrier is transmitted during QSK
operation when using the internal keyer.
Setting of the CW sidetone volume level.
Sets the sending speed for the built-in Electronic
keyer.
Sends random Morse Code five-character groups
via the sidetone.
Sets the Dot:Dash ratio for the built-in electronic
keyer.
Setting of the DCS code.
Selects “Normal” or “Inverted” DCS coding.
Setting of the DIAL knob’s tuning speed.
Defines the displayed frequency offset during DIG
(USER-L or USER-U) mode operation.
Adjusts the audio input level from terminal
equipment during DIG (Digital) mode operation.
Selects the mode and sideband in the DIG (Digital)
mode.
Defines the carrier frequency offset during DIG
(USER-L or USER-U) mode operation.
Sets the gain of the VOX circuitry’s input level for
the DIG mode.
Selects the illumination color for each operating
status.
Setting of the display contrast level.
Setting of the display brightness level.
Sets up the LCD Lamp mode.
Setting of the bandwidth for the DSP CW audio
filter.
Adjusts the low-cut characteristics of the DSP HPF
filter.
Adjusts the high-cut characteristics of the DSP LPF
filter.
Sets the DSP microphone equalization pattern.
Setting of the degree of DSP Noise Reduction.
Enables Tx/Rx operation on the Alaska Emergency
Channel, 5167.5 kHz.
Adjusts the microphone gain level for the FM
mode.
Selects the tuning steps for the SELECT knob in
the FM mode.
Enables/disables the moving of HOME channel
data to the VFO.
Selects the operation of the front panel’s LOCK
key.
Enables/disables the memory grouping feature.
Stores Alpha-Numeric “Tags” for the memory
channels.
Selects the function which is engaged when you
press the SELECT knob.
Enables/disables scanning access via the
microphone’s
[
UP
]
/
[
DWN
]
keys.
Available Values
CAT/LINEAR/TUNER
SEL, MAIN
ON/OFF
USB/LSB/AUTO
FULL/
30 ~ 3000 msec
NORMAL/REVERSE
ELEKEY/MICKEY
400 ~ 800 Hz
10/15/20/25/30 ms
0 ~ 100
4 ~ 60 wpm (1wpm/step)/
20 ~ 300 cpm (5cpm/step)
N, A, AN
1:2.5 ~ 1:4.5
104 Standard DCS codes
Tn-Rn/Tn-Riv/Tiv-Rn/
Tiv-Riv
FINE/COARSE
–3000 ~ +3000 Hz
0 ~ 100
RTTY-L/RTTY-U/PSK31-L/
RTTY-L/PSK31-U/
USER-L/USER-U
–3000 ~ +3000 Hz
0 ~ 100
1 ~ 13
1 (Dim) ~ 3 (Bright)
OFF/AUTO1/AUTO2/ON
60/120/240 Hz
100 ~ 1000 Hz
1000 ~ 6000 Hz
OFF/LPF/HPF/BOTH
1 ~ 16
ON/OFF
0 ~ 100
5/6.25/10/12.5/15/20/25/
50 kHz
ON/OFF
DIAL/FREQ/PANEL/ALL
ON/OFF
CW SIDETONE,
CW SPEED,
MHz/MEM GRP,
MIC GAIN, NB LEVEL,
RF POWER, STEP
ON/OFF
Default
CAT
SEL
OFF
USB
250 msec
NORMAL
ELEKEY
700 Hz
10 ms
50
12 wpm
(60 cpm)
N
1:3.0
023
Tn-Rn
FINE
0 Hz
50
RTTY-L
0 Hz
0
FIX: 26
5
3
AUTO2
240 Hz
100 Hz
6000 Hz
OFF
8
OFF
50
2
ON
DIAL
OFF
MHz/
MEM
GRP
ON
No Menu Item
020 CAT/LIN/TUN
021 CLAR DIAL SEL
022 CW AUTO MODE
023 CW BFO
024 CW DELAY
025 CW KEY REV
026 CW PADDLE
027 CW PITCH
028 CW QSK
029 CW SIDE TONE
030 CW SPEED
031 CW TRAINING
032 CW WEIGHT
033 DCS CODE
034 DCS INV
035 DIAL STEP
036 DIG DISP
037 DIG GAIN
038 DIG MODE
039 DIG SHIFT
040 DIG VOX
041 DISP COLOR
042 DISP CONTRAST
043 DISP INTENSITY
044 DISP MODE
045 DSP BPF WIDTH
046 DSP HPF CUTOFF
047 DSP LPF CUTOFF
048 DSP MIC EQ
049 DSP NR LEVEL
050 EMERGENCY
051 FM MIC GAIN
052 FM STEP
053 HOME-->VFO
054 LOCK MODE
055 MEM GROUP
056 MEM TAG
057 MEM/VFO DIAL MODE
058 MIC SCAN
97

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Yaesu-FT-857D

Zoeken resetten

  • Hoe komt het dat ik de 2 mtr repaeter niet open krijg , ,terwijl alle settings goed staan ??
    Ik bezit de Yaesy FT857D , ,de 70 cm repeater ,werkt vrijwel meteen ,
    Maar de 2 mtr ,helaas niet ondanks 885 tone en - 0,6 Mhz voor de split !!
    Vriendelijk dank ,
    C.J.Klunder
    PD7BRW c.klunder@chello.nl Gesteld op 11-6-2023 om 14:49

    Reageer op deze vraag Misbruik melden
  • ik zoek de instelling van het menu van de FT857D om ham radio deluxe te kunnen installeren Openen ik ben na een update alles kwijt geraakt en krijg het niet weer geinstalleerd geopend
    ik heb de laatste betaalde versie, email graag met nummers van het menu naar
    PA3DFV@gmail .com Gesteld op 8-8-2022 om 15:56

    Reageer op deze vraag Misbruik melden
  • Als ik ga zenden in cw dan heb ik geen output. de andere mode's wel. Yaesu 857d. pa3dmx@veron.nl Gesteld op 28-11-2020 om 14:03

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FT-857D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FT-857D in de taal/talen: Engels als bijlage per email.

De handleiding is 4,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info