496958
4
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
6 7
GETTING STARTED
1. Remove unit and AC adapter from the box and properly
dispose of any protective packaging material.
2. Open battery compartment cover on the bottom of the
unit by sliding it back and lifting up the edge without
the finger slot. Insert 3 AAA batteries as indicated in the
compartment and close cover.
3. Place unit on a level surface close to a power outlet
following the precautions listed in the safety warnings.
4. Locate the back support and insert it into slot behind
the dock connectorby aligning the groove with the rear
support. Push down until an audible snap is heard. This
will lock the rear back support into place.
5. Untie and extend the FM antenna connected on the back
of unit for best reception.
TO DOCK IPOD, IPHONE, IPAD
Pull dock towards the display to lock into place.
Dock iPod, iPhone, iPad onto dock and rest against back
support.
Dock is designed to lock and rotate in order to work with
iPod, iPhone, iPad still in most protective cases.
PLUGGING IN THE UNIT
1. If located in the US, skip to step 5. If located outside
the US, select the appropriate wall adapter. If already
attached to the unit, skip to step 5.
2. Using a small object like a pen, press the button under
the wall adapter to release the adapter.
3. Gently slide in the appropriate wall adapter. You will
hear a click when it is properly locked into place.
4. Connect the AC adapter jack to the back of the unit
labeled 12V and then connect the other end of the
adapter to a power outlet.
5. When the unit is first powered on. The Display will show
‘LUNA’ for 5 seconds and be in standby mode.
BASIC OPERATION
Press SNOOZE/SOURCE to cycle through iPod -> Radio -> Aux
-> STANDBY
To automatically enter standby mode from iPod, Radio or
Aux modes, press and hold SNOOZE/SOURCE for 2 seconds.
DIMMER SETTING
Display brightness can only be adjusted in standby mode or
by the app in all modes.
In order to meet EuP requirements the display brightness is
defaulted to mid level.
To adjust display brighness while in standby mode press (+)
to increase and press (-- ) to decrease.
There are four settings: High/Mid/Low/Off.
Note: If the display brightness is off when the alarm sounds,
the display brightness will be changed to mid setting.
Unit display brightness will automatically be set to mid
upon entering the standby mode.
VOLUME UP / DOWN
Press (+) to increase the volume and press (--) to decrease
the volume (0 to 20). The number will be visible on the
display during this adjustment. It will time out after 2
seconds.
Volume can be adjusted in all playback modes.
Default volume level is set to level 10 for 1st time usage.
The volume level will be remembered when the unit is
switched to standby mode and will resume when the unit
is switched to a playback mode.
SETTING THE TIME WITH IPOD, IPHONE, IPAD
Dock either iPod/iPhone/iPad and the unit will
automatically set the time from device. Use of 12 or 24 hrs
will also follow iPod/iPhone/iPad after synced.
Note: Time Sync function can be used from most of the iPod/
iPhone/iPad models, except some old models such as iPod
mini, iPod 3G, 4G. Clock time of main unit itself is default at
12 hours
If time does not set automatically when an iPod/iPhone/
iPad is docked, the clock will need to be set manually.
SETTING THE CLOCK MANUALLY
(IN STANDBY MODE ONLY):
To set the clock time manually:
1. In standby mode, press and hold SNOOZE/SOURCE for 2
seconds to enter the clock setting mode.
2. The hour will blink, Press (+) to increase the hour or (-- )
to decrease the hour (or press and hold either (+/-- ) to
fast tune). Press SNOOZE/SOURCE once to confirm, then
minute will blink.
Note: Be sure to observe the AM indicator on the display to
ensure the proper time is set correctly
3. Press (+) to increase the minute or (-- ) to decrease
the minute (or press and hold (+/-- ) to fast tune). Press
SNOOZE/SOURCE once to confirm and exit the clock
settings mode.
ALARMS
To set the alarm time:
1. In standby mode, press and hold 1 /2 for 2 seconds to
enter the alarm setting mode.
2. The hour will blink, Press (+) to increase the hour or (-- ) to
decrease the hour (or press and hold (+/-- ) to fast tune).
Press 1 /2 once to confirm, then minute will blink.
3. Press (+) to increase the minute or (-- ) to decrease the
minute (or press and hold (+/-- ) to fast tune). Press 1 /2
once to confirm.
4. The current alarm source will blink (iPod by default), press
(+) or (-- ) to select iPod or Radio or Chime, press 1 /2 once
to confirm, then the volume setting will blink.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw XtremeMac Luna Voyager II bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van XtremeMac Luna Voyager II in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 0,83 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info