308265
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
5019 301 01028
Programme
Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)*
Cotton 95 6.0 59** 1.90 2:00
Cotton with “Eco” *** 60 6.0 49 1.14 2:20
Cotton 40 5.0 56 0.70 2:00
Synthetics 60 2.5 50** 0.80 1:35
Synthetics 40 2.5 46 0.50 1:20
Delicates 30 1.5 60 0.50 0:45
Daily load 40 3.0 41 0.50 1:00
Quick wash 30 3.0 41 0.40 0:30
Wool 40 1.0 60 0.50 0:45
Handwash 40 1.0 45 0.50 0:40
Handwash 30 1.0 45 0.40 0:36
Add detergents as indicated on the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
1. Turn the programme selector to the desired
programme and temperature.
2. The time display shows the duration of the chosen
programme (in hours and minutes), and the
“Start/Pause” indication lamp is flashing.
3. The indication lamp of the predefined spin speed
lights up.
CONSUMPTION DATA
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the
home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type
of wash.
* The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions
applicable at the time.
**
To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
*** Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR AND
SELECT THE PROGRAMME
SELECT ANY DESIRED OPTION
Push the button(s) of any option(s) desired - the
respective indication lamp lights up.
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of options are
deselected automatically.
“Eco” button
With a modified temperature profile and a slightly
prolonged washing duration, the optimum
combination of excellent washing result and even
lower energy consumption is achieved.
“Prewash” button
Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 15 min.
Do not use liquid detergent for the main wash when
activating the Prewash option.
Whirlpool is a registered trademark of Whirlpool USA.
“Easy ironing” button
Can be used together with “Cotton”, “Synthetics”
and “Daily load” programmes to make ironing easier.
Increases the water quantity and the clothes are
spun very gently.
“Cold wash” button
With this option, water is heated only up to 20ºC.
Suitable for delicate laundry items with wash
temperature recomendation of max. 30ºC on the
care label.
Selectable only on the lowest temperature
step of each programme.
“Rinse hold” button
The laundry remains in the last rinse water without
pregressing to the final spin cycle to avoid creasing
and prevent colours from changing.
This option is particularly recommended for the
programmes “Synthetics”, “Daily load” and
“Delicates”.
It is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only.
If you select “Rinse hold” do not leave items to soak
for too long.
Note: The programme stops to “Rinse hold” at the
time the “Rinse hold” lights in the preogramme
sequence indication is on. The indication lamp next
to the “Start/Pause” button flashes.
Terminate the “Rinse hold” option:
Press the “Start/Pause” button; the programme
will terminate automatically with the final spin cycle
for the present wash programme.
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the lamp
lights to show the the door can be opened. As long
as a wash programme is running, the door remains
locked and must on no account be forced open.
In case you have an urgent need to open it during a
running programme, refer to “Cancel (Reset) a running
programme before the end”.
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be caused
by a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your “Instructions for Use”;
if the fault persists, contact our After Sales Service.
Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap: if the indications still lights up, refer to
the
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned: in the
latter case refer to the Instructions for Use (“Removing
the Filter”).
PROGRAMME START
Open the tap and press the “Start/Pause” button.
The indication lamp next to the “Start/Pause” button
lights up. The programme sequence indicator shows
the current programme phase, running from left to
right through Wash, Rinse, Spin/Drain.
The time display shows the remaining programme
time. Due to variations in load and temperature of inlet
water, the remaining time is newly calculated in certain
programme phases. If this is the case, an animation
appears on the time display.
PROGRAMME END
All the lights of the programme sequence indicator
are off, and the “Door open” indication lights up.
1. Turn the programme selector to the “Off/O
position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the “Start/Pause” button to pause the
programme. The light flashes.
2. Select the new programme (with temperature), any
options and another spin speed if you want.
3. Press the “Start/Pause” button again. The new
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.
CANCEL (RESET) A RUNNING PROGRAMME
BEFORE THE END
The “Reset” button cancels a programme before the
end.
Press the “Reset” button for at least 3 seconds;
rES” appears on the display. Any existing water
is drained out before the door can be opened.
If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain” programme
and press the “Start/Pause” button.
Variable spin” button
Every programme has a predefined spin speed.
Press the button to set another spin speed.
If spin speed “0” is selected, the final spinning is
cancelled but intermediate spin peaks remain during
the rinse. The water is drained out only.
The “Start Delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is cheaper. Do not use liquid detergent when
activating “Start delay” option.
Select programme, temperature and options.
Press the “Start delay” button to select the delay
time by 1 to 23 hours.
Press the “Start/Pause” button.
The countdown of the delay time begins; the “Start
delay” indication lamp and the dot on the display will
keep blinking until the programme starts.
The time delay indication disappears when the
programme starts and it is replaced by the remaining
programme time.
Once having pressed the “Start/Pause” button, the
number of hours preselected can be reduced by
pressing again the “Start delay” button.
To cancel the “Start delay
..before you press the “Start/Pause” button:
Turn the programme selector to another position or
press the “Reset” button.
..after having pressed the “Start/Pause” button:
Press the “Reset” button for at least 3 seconds - the
start delay time disappears from the time display.
START DELAY
2

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Whirlpool-awo-866-6kg

Zoeken resetten

  • Bij onze wasmachine komt zwarte prut mee door de gaatjes van de dichtingsring bij de deur. Hoe kan ik dat schoonmaken? Gesteld op 23-3-2020 om 17:51

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Whirlpool awo 866 6kg bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Whirlpool awo 866 6kg in de taal/talen: Engels als bijlage per email.

De handleiding is 0,5 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Whirlpool awo 866 6kg

Whirlpool awo 866 6kg Snelstart handleiding - Nederlands - 2 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - Nederlands - 13 pagina's

Whirlpool awo 866 6kg Snelstart handleiding - Deutsch - 2 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - Deutsch - 14 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - English - 14 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - English - 13 pagina's

Whirlpool awo 866 6kg Snelstart handleiding - Français - 2 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - Français - 13 pagina's

Whirlpool awo 866 6kg Gebruiksaanwijzing - Türkiye - 13 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info