308192
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
5019 301 06243
Whirlpool is a registered trademark of Whirlpool USA
Add detergent as indicated on the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
Close the door and turn the programme selector to the
desired programme and temperature. The indication lamp
next to the
“Start (Pause)”
button blinks and the
indication lamp of the predefined spin speed lights up.
Push the button(s) of any option(s) desired - the respective
indication lights up.
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of options are
deselected automatically.
“Prewash” button
Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 15 min.
Do not use liquid detergent for the main wash when
activating the Prewash option.
“Eco” button
With a modified temperature profile and a slightly
prolonged washing duration, the optimum
combination of excellent washing result and even
lower energy consumption is achieved.
“Intensive rinse” button
More water is added and rinse cycle is prolonged.
This option is particularly suitable for areas with very
soft water, washing baby linen and helps people with
allergies.
“Rinse hold” button
The laundry remains in the last rinse water without
progressing to the final spin cycle to avoid creasing and
prevent colours from changing.
This option is particularly recommended for the
programmes “Synthetics”, “Daily load” and
“Delicates”.
It is particularly useful if you want to postpone spinning
to a later time, or if you want to drain only.
If you select “Rinse hold” do not leave items to soak
for too long.
Note:
The programme stops to “Rinse hold” at the
time the “Rinse hold” light in the programme sequence
indication is on. The indication lamp next to the
“Start
(Pause)”
button flashes.
Terminate the “Rinse hold” option:
Press the
“Start (Pause)”
button; the programme
will terminate automatically with the final spin cycle for
the present wash programme.
If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain” programme
and press the
“Start (Pause)”
button.
CONSUMPTION DATA
Programme
Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme Duration
(hours : minutes)
Cotton 95 6.0 59
*
1.90 2:00
Cotton with “Eco”
**
60 6.0 49 1.02 2:10
Cotton 40 5.0 56 0.70 2:00
Synthetics 60 2.5 50
*
0.80 1:35
Synthetics 40 2.5 46 0.50 1:20
Delicates 30 1.5 60 0.50 0:45
Daily load 40 3.0 41 0.50 1:00
Quick wash 30 3.0 41 0.40 0:30
Wool 40 1.0 60 0.50 0:45
Handwash 40 1.0 45 0.50 0:40
Handwash 30 1.0 45 0.40 0:36
Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
*
To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
**
Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
SELECT ANY DESIRED OPTION
Variable spin” button
Every programme has a predefined spin speed.
Press the button to set another spin speed.
If spin speed “0” is selected, the final spinning is
cancelled but intermediate spin peaks remain during
rinse. The water is drained out only.
The “Start Delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is cheaper. Do not use liquid detergent when
activating “Start delay” option.
Select programme, temperature and options.
Press the “Start Delay” button to select the delay time
by 1, 3, 6, 9 or 12 hours.
Press the
“Start (Pause)”
button.
The indication over to the “Start Delay button lights
up and goes off when the programme starts.
Once having pressed the
“Start (Pause)”
button, the
countdown of the time delay begins. When the
programme starts, the start delay indicator light goes off
and is replaced by the programme sequence indication.
•After the
“Start (Pause)”
button has been pressed,
the number of hours preselected can be reduced by
pressing again the “Start Delay” button.
To cancel the “Start Delay
..before you press the “Start (Pause)” button:
Turn the programme selector to another position or
press the
“Reset”
button.
..after having pressed the “Start (Pause)” button:
Press the
“Reset”
button for at least 3 seconds - the
start delay indicator light goes out.
Open the tap and press the
“Start (Pause)”
button. The
indication lamp next to the
“Start (Pause)”
button lights
up. The programme sequence indicator shows the current
programme phase, running from left to right through
Wash, Rinse, Spin/Drain.
When the programme phase is finished, the corresponding
indication goes out.
Before starting and after end of a programme, the lamp
lights to show that the door can be opened. As long as a
wash programme is running, the door remains locked and
must on no account be forced open. In case you have an
urgent need to open it during a running programme, refer
to “Cancel (Reset) a running programme before the end”.
“Service”
Lighting up of the “Service” indication can be caused by a
fault in an electrical component. Refer to the
“Troubleshooting Guide” in your Instructions for Use; if
the fault persists, contact our After Sales Service.
“Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap; if the indication still lights up, refer to the
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the drain
hose is kinked or the filter must be cleaned; in the latter case
refer to the Instructions for Use (“Removing the Filter”).
All the lights of the programme sequence indicator
are off, and the “Door open” indication lights up.
1. Turn the programme selector to the “Off/O” position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
1. Press the
“Start (Pause)”
button to pause the
programme. The light flashes.
2. Select the new programme (with temperature), any
options and another spin speed if you want.
3. Press the
“Start (Pause)”
button again. The new
programme continues at the same position where the
previous programme was interrupted. Do not add
detergent for this programme.
The
“Reset”
button cancels a programme before the end.
Press the
“Reset”
button for at least 3 seconds. Any
existing water is drained out before the door can be
opened.
START DELAY
PROGRAMME START
“DOOR OPEN” INDICATION
RED INDICATIONS
PROGRAMME END
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
30106243GB.fm Page 2 Monday, January 5, 2009 12:00 PM
Black process 45.0° 150.0 LPI
2

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Whirlpool-awo-646

Zoeken resetten

  • Mijn wasmachine startte en viel nadien stil in het midden van een programma. Nu wil het niet meer starten en er brandt geen enkel lampje meer. Wat kan hiervan de oorzaak zijn? Gesteld op 30-6-2022 om 08:21

    Reageer op deze vraag Misbruik melden
  • L.S., naast de Gknop, centrifugetoerental, staan nog drie knoppen met symbolen,een doorstreepte cirkel, een sproeisymbool en een mand, waarvan de betekenis niet beschreven is. Wat betekenen die aub ?
    F. de Mey Gesteld op 15-3-2020 om 08:50

    Reageer op deze vraag Misbruik melden
  • Mijn wasmachine startte en viel nadien stil in het midden van een programma. Nu wilt hij niet meer starten en er brandt geen enkel lichtje meer.
    Kan iemand me helpen? Gesteld op 18-7-2016 om 21:03

    Reageer op deze vraag Misbruik melden
  • Kan iemand mij vertellen wat de oorzaak is van van het volgende:

    Mijn wasmachine WHIRLPOOL AWO 646 staat er als 'dood' bij. Het lijkt wel alsof het snoer niet in de stekker steekt.

    Heb zelf al volgende zaken nagegekeken:
    1/ zekeringen in zekeringkast zijn o.k.
    2/ stekker waar wasmachine is op aangesloten heeft stroom.
    3/ filter volledig uitgekuist ( was eigenlijk niet vuil) en 1l water via wasbakje in wasmachine
    gegoten om ECO-systeem te activeren>geen resultaat

    Alvast bedankt voor uw reactie.

    Mijn e-mailadres is: benjamin.desmedt@hotmail.be Gesteld op 9-11-2013 om 16:31

    Reageer op deze vraag Misbruik melden
    • Best Hendrik,

      Toen mijn wasmachine hetzelfde mankement vertoonde , is de programmerknop moeten vervangen worden.

      Misschien zal dit bij uw machine ook moeten gebeuren.

      Met vriendelijkle groeten,

      Benjamin De S medt Geantwoord op 23-11-2015 om 09:04

      Waardeer dit antwoord Misbruik melden
  • Wat willen de symbolen rechts op de wasmachine zeggen?

    Kan je ergens aangeven dat de wasmachine maar half gevuld is en dus minder lang moet draaien bv? Gesteld op 11-5-2012 om 17:26

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Whirlpool awo 646 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Whirlpool awo 646 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,28 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Whirlpool awo 646

Whirlpool awo 646 Snelstart handleiding - Nederlands - 2 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - Nederlands - 13 pagina's

Whirlpool awo 646 Snelstart handleiding - Deutsch - 2 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - Deutsch - 14 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - English - 14 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - English - 13 pagina's

Whirlpool awo 646 Snelstart handleiding - Français - 2 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - Français - 13 pagina's

Whirlpool awo 646 Gebruiksaanwijzing - Türkiye - 13 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info