607070
7
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
7
EN
Refer to the Programme Chart to check if options are available for the
selected programme
OPTIONS which are directly selectable by pressing the
dedicated button
Fresh Care
Helps to keep your laundry fresh if you cannot unload it
soon after programme end.
The washing machine will start to tumble the laundry
periodically a short time after programme end. This tumbling will
last up to approximately 6 hours after end of your wash programme.
You can stop it at any time by pressing any button; the door unlocks
and you can take out your laundry.
OPTIONS which are selectable by pressing the Options
button
Prewash
Helps to clean heavily soiled laundry by adding a prewash
phase to the wash programme selected.
Extends the programme by about 20 minutes.
For adding detergent to the prewash phase
automatically: make sure that the auto dosing system is activated
(see FUNCTIONS / Auto Dosing)
manually: add the detergent portion for the prewash phase
directly to the drum in a detergent ball, before starting the
programme.
Hot Finish
The programme ends with a warm rinse phase. This relaxes
the bres of your laundry, and the laundry feels
comfortably warm when taking it out a short time after
programme end.
Bio Stains 1
Helps to remove all kinds of stains, except grease/oil.
The programme begins with a cold water wash phase.
Extends the programme by about 10 minutes.
Pre-treatment recommended for stubborn stains.
Not selectable for Cotton 95°C.
Colours 15°
Helps to preserve the colours of your laundry by
washing it with cold water (15°C). Saves energy for
water heating, while keeping a good wash result.
Suitable for lightly soiled coloured laundry without stains.
Make sure that your detergent is suitable for cold wash
temperatures (15 or 20 °C).
Not selectable for Cotton 95 °.
Heavy Soil
Helps to clean heavily soiled, stained laundry by optimising
the eciency of additives for stain removal.
Add an appropriate amount of in-wash additive for stain
removal (powder) to the manual detergent dosing compartment,
together with your detergent (powder only). May extend the
programme by up to 15 minutes.
Appropriate for use with oxygen-based stain removers and
bleaching agents.
Chlorine or perborate bleaches must not be used!
Intensive Rinse
Helps to avoid detergent residues in the laundry by
extending the rinse phase.
Particularly suitable for washing baby laundry, for people
suering from allergies and for areas with soft water.
Rapid
Enables quicker washing.
Recommendable for only lightly soiled laundry.
Not selectable for Cotton 95 °C.
FUNCTIONS
Auto Dosing
Automatically dispenses liquid detergents and
fabric softener (if needed) from the tanks of the
detergent dispenser. To enable a correct dosage, this
function needs to be set up as mentioned in section
FIRST TIME USE/Auto Dosing, and as described in
detail in the USE AND CARE GUIDE/AUTO DOSING –
FIRST USE.
Once you have completed the set-up, make sure that
the tanks are lled with detergent/fabric softener according to the
selected conguration:
If you use fabric softener:
» Tank 1: detergent
» Tank 2: fabric softener
In this conguration, when setting up a programme, Tank 1 and
Tank 2 buttons light up to indicate that the right amount of
detergent and softener will be dispensed, once the programme is
started. If in certain cases you do not want to dispense softener,
simply disable Tank 2 by pressing the corresponding button.
If you do not use fabric softener:
» Tank 1: main detergent
» Tank 2: secondary detergent
In this conguration, when setting up a programme, you can only
select one tank. Make sure that the correct tank is selected,
according to the detergent you want to use for the selected
programme. The detergent will be dispensed only from the tank for
which the related button lights up.
If occasionally you prefer to dose the detergent manually (for
instance because you want to use another detergent), simply
deactivate the tanks by pressing the buttons, and add the detergent
in the compartment for manual dosing. The deactivation of the
tanks will be valid only for one programme. The Auto Dosing
function will automatically be active again for the next programme
which you set up.
When the supply of detergent/fabric softener in one of the tanks
runs low, the display shows a low level warning when the washing
machine is switched on, and also at the end of the programme. In
addition, the corresponding tank button light blinks a few times.
When this message appears for the rst time, the supply in the
indicated tank is usually sucient for about two or three more
programmes.
When the supply of detergent/fabric softener in one of the tanks
has run out completely, the display shows an empty tank warning
and informs that only manual dosing is possible. The button light of
the empty tank blinks a few times. You have to either rell the
empty tank(s), or dose the detergent manually.
In case you want to permanently deactivate the Auto Dosing
function (because you always prefer to dose manually), press the
Settings button, select Auto Dosing and set the function to O. To
be able to use the function again later, it must be set to On.
IMPORTANT:
Never ll the tanks with powder detergents; powder can only be
used for manual dosing
Softener cannot be dosed manually; it can only be used in Tank 2
of the auto dosing system.
1
2
OPTIONS, FUNCTIONS AND INDICATORS
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Whirlpool FSCR 10433 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Whirlpool FSCR 10433 in de taal/talen: Engels als bijlage per email.

De handleiding is 7,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Whirlpool FSCR 10433

Whirlpool FSCR 10433 Snelstart handleiding - Français - 8 pagina's

Whirlpool FSCR 10433 Gebruiksaanwijzing - Français - 55 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info