GB12
The hood is designed for installation and use as an "Extractor Version" or a "Filter Version".
Extractor Version
IMPORTANT: If you want to use the hood as an "Extractor Version", you will need to purchase the flue kit; this must be ordered and fitted prior
to use.
Fumes are extracted and expelled outside via an exhaust pipe (not supplied) fixed to the hood exhaust pipe outlet connector.
Depending on the exhaust pipe purchased, make provisions for suitable fixing to the exhaust pipe outlet connector.
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recirculated into the surrounding environment.
IMPORTANT: Check that air recirculation is facilitated.
If the hood does not have a carbon filter/s, order one/them and fit it/them before use.
Install the hood well away from very dirty locations, windows, doors and sources of heat.
The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualified technician is required to ensure that the
materials are suitable for your ceiling.
MATERIAL SUPPLIED
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
Remove all components from the packets. Check that all components are included.
• Hood assembled with motor and lamps installed.
• Air outlet protection
• Support bracket
• Assembly template
• Filter/s
• Instruction manual
• 1 adapter Torx T10
• 1 adapter Torx T20
• 1 Washer
• 3 plugs 8 x 40 mm
• 3 screws 5 x 45 mm
• 2 screws 3.5 x 9.5 mm
• 2 Screws M5 x 18
Adjacent wall units
Adjacent wall units
centre line
65 cm (gas or combi cookers)
45 cm (electric cookers)
hob surface
800 mm min.
INSTALLATION DIMENSIONS
