805503
4
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
4
FREN
Température de service
Température d’expédition
et de stockage
0°C - +40°C
-10°C à +50°C
Alimentation électrique 230V ac 50Hz
Protection électrique Classe II - IP33
Type de contact
Charge maximale
2 fils (contact libre) - Connecteurs à vis <1.5mm2
Jusqu’à 8A - 250V ac 50Hz
Radiofréquences 868 MHz, <10mW
Normes et homologations
Votre thermostat a été conçu con-
formément aux normes suivantes
ou autres documents normatifs
EN 60730-1:2017 / EN 60730-2-9:2021 / EN IEC 61000-3-2:2019 + AMD1:2021
EN IEC 61000-3-3:2013 + AMD1:2017 + AMD2:2021 / EN 55014-1:2017
EN 55014-2:2015 / EN 55024:2010 + A1:2015 / ETSI EN 301 489-3 V2.1.1
ETSI EN 301 489-1 V2.2.3 / ETSI EN 300 220-1 V3.1.1 / ETSI EN 300 220-2 V3.2.1
EN IEC 63000:2018 / Regulation (EU) 2015/1188 / Regulation (EU) 2013/813
Caractéristiques techniques
Mode de conguration RF
Technical characteristics
Radio conguration mode
1. Installez et branchez le récepteur en respectant les consignes suivantes :
Prêtez une attention particulière au choix de l’emplacement de votre récepteur, en effet quelques précautions sont à prendre
afin de garantir un fonctionnement optimal de votre installation :
- Le récepteur radio fréquence ne devrait pas être placé trop prés de canalisation électrique, hydraulique ou de tout type
d’appareil de communication sans fils (GSM, Wi-Fi…). Une distance d’environ 50cm vous garantira un fonctionnement optimal.
- Veillez à couper l’alimentation électrique avant toute intervention sur les borniers de connexion.
- Brancher votre récepteur au secteur.
2. Ensuite maintenez le bouton poussoir enfoncé pendant 5s, le voyant RF vert doit s’allumer (fixe) indiquant que le récepteur
est désormais en mode de configuration radio en attente de l’adresse de configuration d’un thermostat
3. Référez-vous à la notice du thermostat pour configure le thermostat en mode “RF Init”.
4. Vérifiez que les signaux radio sont correctement reçus par le récepteur. Sur le récepteur, la led verte doit clignoter à chaque
réception d’un signal radio provenant du thermostat.
5. Sortez du mode de configuration Radio du thermostat. (se référer à la notice du thermostat).
6. Votre installation est prête à l’emploi.
1. Install and plug the receiver into the following guidelines:
Pay attention before the installation of your receiver, some routing rules should be make to guaranty an optimal working.
- The receiver must be put at a minimum distance of 50cm of all others electrical or wireless materials like GSM, Wi-Fi router.
- Before wiring work related to the receiver must be carried out only when de-energized.
- Plug your receiver to the power supply.
2. Then press the Receiver push button during 5sec, the Green RF LED should lit up (fixed) indicating that the Receiver is now
in radio configuration mode waiting for a thermostat configuration address.
3. Please refer to the thermostat leaflet for enter the thermostat in “RF Init” mode.
4. Verify that radio signals are correctly received by the Receiver. On the Receiver, the Green LED should blink at each radio
signal received from the thermostat.
5. Exit the Radio configuration mode on the thermostat. (Please refer to the thermostat leaflet).
6. Now starting your installation is ready to works.
Environment (Temperatures)
Operating
Transport and storage
0°C - +40°C
-10°C to +50°C
Power supply 230V ac 50Hz
Electrical protection Class II - IP33
Type of contact
Maximum Load
2 wires (free contact) - Screw connectors <1.5mm2
Up to 8A - 250V ac 50Hz
Radio Frequency 868 MHz, <10mW
Norms and homologations
Your thermostat has been designed
in conformity with the following
standards or other normative
docmuents
EN 60730-1:2017 / EN 60730-2-9:2021 / EN IEC 61000-3-2:2019 + AMD1:2021
EN IEC 61000-3-3:2013 + AMD1:2017 + AMD2:2021 / EN 55014-1:2017
EN 55014-2:2015 / EN 55024:2010 + A1:2015 / ETSI EN 301 489-3 V2.1.1
ETSI EN 301 489-1 V2.2.3 / ETSI EN 300 220-1 V3.1.1 / ETSI EN 300 220-2 V3.2.1
EN IEC 63000:2018 / Regulation (EU) 2015/1188 / Regulation (EU) 2013/813
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Watts WAT BT-RRF FREE CONTACT - Wireless Wall receiver bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Watts WAT BT-RRF FREE CONTACT - Wireless Wall receiver in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 1.2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info