3
Model No. & Specifications:
Model No: WPM60
Voltage: AC 120V~60Hz
Input Power: 1000W
Please read this user manual carefully before assembling and using.
BEFORE FIRST USE
– With a damp cloth, wipe the kettle and internal surfaces of the popcorn maker.
– Dry thoroughly.
ASSEMBLING
NOTE: Make sure the popcorn maker is unplugged before you do the following:
– Install the kettle by the pivots on the supporters, which are built into the roof of the
unit.
– Connect the kettle plug to the socket located on the front right roof panel and twist to
lock into place.
– Attach doors to the door frames by inserting hinge pins into the hinges on each side of
the front of the unit.
OPERATING INSTRUCTIONS
NOTE: All foodservice equipment should be operated by trained personnel.
1. Your Waring Commercial Popcorn Maker has 3 function switches:
I. Warming Light
II. Kettle Stirrer
III. Stainless Steel Kettle Heater
2. Plug the popcorn maker power cord into the wall outlet.
3. Switch on the warming light and heater (I & III), and then pour in recommended
amount of oil. Recommended oil amount is ¼ - ¹⁄3 cup (0.6-0.8 litre).
4. Kettle should be pre-heated for 3 to 4 minutes with oil (until steam starts coming out
from the kettle).
5. Measure 1 cup of popcorn kernels, open the kettle lid and pour in kernels. Salt can
also be added to the mixture. Close the kettle lid.
Caution: Lid may be hot. Use oven mitts or potholders.
6. Switch ON the Stirrer (II) immediately to begin the popping process.
7. You can close the 2 front doors while popping (or leave them open to reduce cabinet
moisture).
8. Popcorn starts popping out through the lid after about 2 to 3 minutes.
9. When popping stops, open doors, hold the red insulated kettle handle and empty the
remaining popcorn from the kettle by turning counterclockwise.
NOTE: Additional batches of popcorn can be popped immediately.
10. Switch off the stirrer and heater (II & III) when popping is completed. The warming
light (I) can remain on to display and keep popcorn warm.
11. Serve your popcorn with popcorn scoop provided.
12. Remove plug from power supply when the unit is not in use.
13. Repeat step 5 to 9 to continue popping. NOTE: Oil does not have to be preheated if
popping continuously.
CAUTION: DO NOT LEAVE POPCORN POPPER UNATTENDED WHILE IN USE.
