ENGLISH
5
HOW TO FILL WITH WATER
The appliance is equipped with an
automatic filling system, and may be
filled with water while the boiler is
under pressure.
Each time the appliance is used, a few
drops of water may come out of
the nozzle when the start button is
pressed for the first time.
This is quite normal and is due to
condensation which forms when the
tube is still cold. The same thing may
happen after an interval of any great
length.
ATTENTION!
Do not use distilled or deminerali-
zed water. It could cause the unit to
malfunction.
Press the button to use the iron.
The iron can be used without the
steam boiler, for no-steam ironing.
When used with the steam boiler, the
appliance automatically switches to
economy mode.
The warning light switches on to
indicate that the iron is operating in
the economy mode.
Wait a few minutes until the heating
element light switches off. Steam
is now available for cleaning or
ironing.
During initial start up when the blue
light comes on, it is now time to burp
or purge the system.
NOTE: while the appliance is in use,
the heating element light will
switch on and off several times; this
heating element light may be ignored
while the appliance is being used.
An electronic bell will ring to warn
that there is no water in the heater.
The low water light indicates that
the cold water reservoir is empty. The
appliance has a power save mode
which is activated automatically when
steam is not used for a few minutes.
The ironing is normally done in the
power save mode.
LCD DISPLAY
The appliance is equipped with an
LCD display showing pressure and
temperature conditions in the heater,
general conditions of the appliance
and malfunctions of heating or
hydraulic systems.
Depending on the appliance state,
display shows the messages below.
Temperature and pressure value indi-
cated below are purely indicative.
STARTING UP THE VAPOR
SYSTEM
Insert the plug into the electrical
socket. Press the start button .
The heating element light
switches on. This shows that the ap-
pliance is working. After initial check,
a message may appear on the LCD
screen indicating the boiler requires
cleaning. An electronic bell will ring
intermittently. If the boiler has already
been cleaned, ignore this message.
