836185
9
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
9
GB
2) Turn the quick release cord hooks to release the power cord (Fig. 8).
3) Plug the power cord into a power outlet.
WARNING:
If any abnormality/failure occurs, stop using the product immediately and
disconnect the power plug.
4) Press the power button to turn the carpet cleaner on (Fig. 9).
5) For spills, rst collect any excess liquid before using water/solution. Place the cleaning nozzle
towards the front of the spill and slowly pull backwards over the area.
6) To dispense cleaning solution, hold the tool about 2.5 cm over the area to be cleaned. Squeeze
the spray trigger to release a mix of water and cleaning solution (Fig. 10).
7) Release the trigger and use the brush on the nozzle to agitate cleaning area by scrubbing.
8) To lift away the stain, tilt the nozzle to make contact with surface and pull the tool backward
slowly to vacuum up excess dirty liquids. Repeat as necessary (Fig. 11).
NOTE:
Ensure the nozzle is in contact with the surface, over or under tilting may result in poor pick
up.
9) Once you have completed cleaning, press the power button and unplug the power cord.
CAUTION: THERMAL PROTECTOR
This carpet cleaner is equipped with thermal protector which automatically protects the
machine should it overheat. When the thermal protector activates, the attached nozzle will
stop spraying.
To reset thermal protector:
Turn the carpet cleaner off and unplug the power cord from the
outlet to allow the carpet cleaner to cool for approximately 30 minutes.
Empty the dirty water tank and check for any obstructions if necessary.
3. Emptying Dirty Water Tank
WARNING:
Always unplug power cord from electrical outlet before performing any service
on carpet cleaner.
Empty the dirty water tank when the dirty liquid reaches the "Max Fill" line and there is a loss in
suction. During normal use, debris may accumulate in the dirty water tank. To keep the carpet
cleaner functioning properly, rinse out the dirty water tank with clean water after each use and
leave to air dry before retting.
1) Remove the dirty water tank from the side of the unit (Fig. 12).
2) Release the dirty water tank cover to open (Fig. 13).
3) Empty the tank into a sink or toilet. Rinse the tank thoroughly with clean water. Allow the tank to
air dry before reinstalling. DO NOT wash in the dishwasher. DO NOT install damp.
4) Close the tank cover and secure the release latch.
5) Reinstall the dirty water tank back into the unit.
WARNING: The motor noise changes to a higher pitch when the dirty water tank is full
or blocked. Stop the vacuum immediately and empty the dirty water tank.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Vacmaster EasyClean V1 - SCA0801 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Vacmaster EasyClean V1 - SCA0801 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info