489381
5
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
5
Installation instructions
Installation and repair are only to be carried out by an
expert. Always read and follow the operating instructions
carefully prior to starting any work!
The year when the equipment was first taken into oper-
ation must be indicated with a check on the type plate.
Choice of location and installation
Select installation site (not in installation compartment behind
heater) such that the hot water pipes are as short as possible.
The boiler must be easily accessible at all times for service
work and be easy to remove and install.
Securely screw boiler to suitable surface (plywood panel,
laminated wood strips, or metal base) on floor of vehicle with
B 5.5 x 70 screws and washers (1). Always use the support
sleeves (2) that are preinstalled in the factory to reinforce the
insulating jacket.
Water connection
All pressure and submergible pumps up to 2.8 bar are used
for operating the boiler and all mixed combination sets with or
without an electrical switch.
Fig. A
When using immersion pumps, a non-return valve (3 – not
included in the scope of supply) must be fitted between the
pump and the first branch point (arrow points in direction of
flow).
Fig. B
When using pressure pumps with high switching hysteresis,
hot water may flow back through the cold water tap. To pre-
vent the backflow, we recommend that a non-return valve
(4 – not included in the scope of supply) be fitted between the
outlet to the hot water tap and the drain valve.
Hoses with an inner diameter of 10 mm that are pressure-re-
sistant (up to 3.5 bar) and hot water-resistant must be used for
connecting to the boiler and the safety/drain valve.
For non-flexible pipe routing (e.g. John Guest System) Truma
can supply the water connections (5 + 6), the safety/drain
valve (7) and a non-return valve (3 + 4) with a 12 mm diameter
inner connection as accessories.
If connecting to a central water supply (rural or city connec-
tion) or when using more powerful pumps, a pressure reducer
must be used which prevents pressures of greater than 2.8 bar
occurring in the boiler.
Route the water hoses so that they are as short and
free of kinks as possible. All hose connections must be
secured using hose clamps (also for cold water)! Pressures
of up to 3.5 bar can occur in the safety/drain valve (also in
submergible pumps) because of the heat of the water and the
resulting expansion.
We recommend the use of hose clips (part no. 40712-01)
to fasten the hoses to walls or the floor. If gas heating
has been installed, the water hoses and the hose clips can be
laid on the hot air pipes, which prevents frost.
In order to guarantee that the boiler is completely emp-
ty, the enclosed elbow with breather valve (5) must be
used for the hot water connection!
All water pipes should be routed in a descending man-
ner to the safety/drain valve! There shall be no claims
under guarantee for damage caused by frost!
Elektroboiler (Electric boiler)
17
14
5
6
16
8
7
24
1
2
20
3
9
17
14
5
6
16
8
7
9
4
24
20
1
2
A
B
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Truma Elektroboiler bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Truma Elektroboiler in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Deens als bijlage per email.

De handleiding is 1,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Truma Elektroboiler

Truma Elektroboiler Gebruiksaanwijzing - Nederlands, Deutsch, English, Français, Italiano, Espanôl, Dansk - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info