732444
5
Verklein
Vergroot
Pagina terug
1/9
Pagina verder
3. Please ensure the ice cube maker is placed on a stable table or platform to avoid malfunction.
4. The incline angle of the ice cube maker cabinet should not exceed 45° during transportation or use. Do not
turn the ice cube maker upside down otherwise it could cause the compressor or refrigerating system to
operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice cube maker is
moved or transported. Before using the ice cube maker for the first time, please wait for 2 hours after the
unit has been moved and positioned in the proper place.
5. The ice cube maker must be placed on a dry and flat surface with sufficient ventilation, far from heat sources
such as ovens, heaters and corrosive gases. Leave about 15cm space on all sides of the ice cube maker for
proper ventilation.
6. Do not fill the water reservoir with hot water. This may damage the ice cube maker. It is best to fill the water
reservoir with water of room temperature or lower.
7. Do not use the appliance at a very cold environment (lower than 5).
8. Clean the appliance by following the operation of “CLEANING AND MAINTENANCE” before operate.
Using your ice cube maker
1. Ensure that the drain plug at the bottom of the water reservoir is closed well.
2. Plug the ice cube maker into the wall outlet, the “ICE” indicator blinks.
NOTE: please make the ice cube maker be rested for 30 minutes before pluged if it has been moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the “ON/OFF” key, and the “ICE”indicator lights solidly.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature and water
temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over
the next 7-15 minutes ice forms on the evaporator. Once this has completed, the ice tray will tilt backwards
and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then
dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and start the next cycle.
9. The “ICE FULLindicator will light up when the ice basket is full and then the ice cube maker will stop the
ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 5
seconds later, the ice cube maker will restart its ice making function automatically.
10. The ADD WATER” indicator will light up when the water reservoir is lack of water and the ice-making cycle
will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then
press the “ON/OFF” key again to restart the ice-making cycle. The appliance will start working automatically
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Trebs 99363 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Trebs 99363 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,01 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info