(GB) TREBS COMFORTEMP; HOT DRINK DISPENSER (MODEL 21128)
BEFORE USING THE WATER BOILER,READ ALL INSTRUCTION
GENERAL INFORMATION
*Never immerse the appliance in water.
*Never switch on the appliance, if there is no water in tank.
*Always use the appliance on a dry, level and heating –resistant surface away from any edge. Be sure hands are dry.
THE APPLIANCE MUST BE EARTHED
INSTALLATION
*Before using the appliance, first clean the percolator tube and inside of tank with a non- abrassive detergent.
*Place the appliance upright on a firm and flat surface.
*Plug the appliance into a grounded socket while the appliance is switch off.
THE APPLIANCE IS NOW READY TO USE
WARNING:
*The outside of the appliance gets very hot during use. Don’t touch the surface.
*Do not remove the lid while the water is boiling.
*If the appliance is overfilled, boiling water may be spilled.
THERMAL CUT-OUT
The appliance must be unplugged before it can be reset. The appliance is fitted with a thermal cut-out. If this is activated,
the appliance will turn itself off, although the lamp will remain on. In order to make the appliance operational again, the
reset button of the appliance must be pressed once the appliance has cooled down. If the appliance still does not work,
you should consult your dealer. This safety device may have been switched off during transport. If so, follow the above
instructions.
HEATING WATER FOR INSTANT BEVERAGES
Plain water may be heated in your appliance for use with instant beverages. Simply fill the clean appliance with COLD
water or other beverages you would like to heat to the desire cup level. Plug appliance in and switch to ON position.
Switch OFF the appliance and unplug it when less than three cups of water remain.
When the appliance is used to heat water only, it must be thoroughly cleaned WELL after each use. In addition to special
weekly cleaning using vinegar to move mineral deposits, if these deposits are not removed, pitting off the metal can occur
and result in damage to the appliance.
CLEANING AFTER USE.
*Clean the top cover with a non-abrasive detergent and then dry them off with a soft dry cloth. The inside of the tank and
the percolator tube are made of stainless-steel and can be cleaned with a scouring agent, possibly in combination with
a scouring pad.
*If the appliance is to function properly, the cavity in the middle of the base must be free of lime scale. Use a scale
remover if necessary.