576908
12
Verklein
Vergroot
Pagina terug
1/15
Pagina verder
12
The performance of this appliance meets the requirements of the European Standard
for Domestic Cooking Appliances (EN30) which specifies a maximum allowable
temperature rise of the furniture into which the appliance is installed of 65
o
C above the
ambient temperature. The installer should verify all furniture materials are suitable – ie
plastic materials may have a softening point lower than specified above.
We recommend the installation follows the minimum dimensions shown in this manual
as any deviation could result in excessive temperature rise. If minimum dimensions
must be reduced, due to design constraints, a temperature rise test of all furniture fitted
around the unit MUST be performed. The design is deemed permissible providing the
results of this test comply with all standards in force and the requirements detailed
within the furniture manufacturer’s material specification. Where minimum dimensions
are reduced we recommend protecting with non combustible material.
Gas Connection
Prior to connection ensure the local conditions for gas type and gas pressure match the
appliance specification. (Gas type and pressure for this appliance are printed on the
databadge located on the base of appliance)
The Ø8mm gas inlet is located to the rear of the appliance. Prior to connection remove the
plastic protection plug from the fitting. The appliance MUST be connected using metal pipe
manufactured from either copper, seam welded steel, seamless steel or stainless steel,
which complies to the requirements of EN1949. Rubber tubing MUST NOT be used.
Electrical Connection
Spark Ignition (12V DC)
The spark ignition generator MUST only be connected to a suitable 12V DC supply. We
recommend connecting to the generator using sheathed spade connectors.
Dual Fuel models
(230-240V ~ 50Hz)
Models fitted with power cord only
This appliance is supplied with a double insulated cord, type 227 IEC 53, HO5V V-F, which
is suitable for use up to 4 amps. This should be connected to a double pole switched
mains supply, with 3mm minimum contact separation at all poles in accordance with the
wiring rules. Ensure that all electrical cables and wires are routed well clear of any heat
source, including this appliance. Do not allow the cord to hang loose into the lower
compartment. The switch must be accessible after installation.
Models fitted with plug and power cord (UK only)
This appliance is supplied with a plug attached to the end of the power cord, for
connection to a switched wall mounted socket. After connection ensure the power cord
and any other electrical wires are routed well clear of any heat source, including this
appliance. Do not allow the cord to hang loose into the lower compartment. The switched
socket must be accessible after installation.
INSTALLATION
If the power cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Thetford S-OH70000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Thetford S-OH70000 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,49 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Thetford S-OH70000

Thetford S-OH70000 Gebruiksaanwijzing - Deutsch - 17 pagina's

Thetford S-OH70000 Gebruiksaanwijzing - Français - 15 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info