45187
5
Verklein
Vergroot
Pagina terug
1/66
Pagina verder
A. The refrigerator can be powered by the mains (230V), direct current (12V) or
liquid gas. Select the energy source that you want by means of the energy
source selector switch (A). The switch has four settings:
- direct current (DC) (12V)
- mains supply (230V)
- gas
- switched off
B. The thermostat controls the refrigerator temperature when the refrigerator is
powered from the mains (230 V) or gas. The refrigeration level is indicated by
the dots (the bigger the dot, the colder the setting).
C. The flame meter shows whether the flame is alight. The flame is alight when the
red needle of the meter moves into the green area.
D. Pressing the manual (piezoelectric) starter produces a spark that ignites the
flame in the burner.
4.1.1 Electrical operation
The refrigerator can be powered by electricity in two ways:
- DC (12V): Set the energy source selector switch (A) to
the refrigerator will now be powered by the battery of your car or camper.
Important! - Always use the gas connection or mains voltage to start up the
refrigerator for the first time and to cool it. Powering from the battery of your
vehicle is suitable only for maintaining the temperature of the refrigerator and its
contents once it has been refrigerated.
- When powered by a vehicle battery (12 V) the refrigerator works without
temperature control (i.e. constant operation).
- Mains voltage (230 V): set the power selector switch (A) to
- Set the temperature by means of the thermostat, rotary switch (B). (The bigger
the dot, the colder the setting).
4.1.2 Powering with gas
Warning! - Flammable material must be kept away from the refrigerator.
- For selection of gas type, see the information plate inside your refrigerator.
- For the pressure regulator model, see the information plate inside your
refrigerator and the table at the end of this booklet.
- The type of gas container and its location must be in compliance with the most
recent regulations. Ensure that the unit is installed in a location with good
ventilation and make sure that the ventilation openings in the gas container
storage location remain open.
- The changing of the gas container must be done outside in the open air and out
of reach of any possible sources of ignition.
- You are strongly advised not to use gas to power the refrigerator while you are
driving. If a road accident results in fire, there is a danger of explosion.
- You are strongly advised not to use gas to power the refrigerator in the vicinity
of petrol stations.
1 Open the valve of the gas bottle and the gas taps.
2 Set the Thermostat (B) to the highest level (the biggest dot).
3 Set the energy source selector switch (A) to
4 Ignite the gas flame:
Manual ignition (N80P, N90P, N100P, N112P):
- Press the thermostat (B), and keep it depressed.
- Press the button for manual ignition several times at intervals of between 1 and
UK
2 seconds.
- Release the thermostat when the indicator of the flame meter enters the green
area. If it does not enter the green area, repeat the previous step.
Warning! Never keep the thermostat depressed for longer than 30 seconds. If a
flame does not appear, wait at least five minutes before trying again. If you fail to
observe this rule, there may be an accumulation of gas creating the risk of fire or
explosion.
- Set the desired refrigeration level by means of the thermostat (B). (The bigger
the dot, the colder the setting)
Electrical ignition (N80E, N90E, N100E, N109, N110E, N145E):
- Press the thermostat (B) and keep it depressed.
- Ignition takes place automatically. You will hear a ticking noise. If ignition was
successful, the noise will stop and the flame meter will turn green. Release the
thermostat.
- If the flame goes out, ignition will be repeated automatically.
- Set the desired refrigeration level by means of the thermostat (B). (The bigger
the dot, the colder the setting)
4.2 Switching off the refrigerator
- Set the energy source selector switch (A) to
- The refrigerator is now completely switched off.
- Use the special storage latch on the door locking mechanism to stop the door
from closing. This prevents unpleasant odours and mould in the refrigerator.
Important! If you are not going to use the refrigerator for a prolonged period, close
the valve of the gas bottle and the gas taps.
5 SWITCHING ON THE REFRIGERATOR (control
panel according illustration 7)
- It is recommendable to clean the inside of the refrigerator before you switch on
the refrigerator.
- Let the refrigerator run for at least eight hours before you place food in it for the
first time.
5.1 Smart Energy Selection (SES)
When you start up a refrigerator equipped with Smart Energy Selection (SES) you
should usually select the AUTO mode. The SES system will then automatically
select the best of the three available energy sources.
The system will apply the following priority:
- mains voltage (230 V)
- direct current (12 V)
- liquid gas
If an energy source becomes available that has a higher priority than the source the
refrigerator is currently using (e.g. if your vehicle engine is started), the system will
stop using the current energy source and switch to the energy source with the
higher priority.
If a fault occurs in one or more of the possible energy sources, the system will not
generate an error message while an alternative energy source is still available. The
SES system switches over automatically.
If none of the energy sources is available, the LED of the main switch will turn
from green to red and flash every second.
SES models additionally allow you to select the desired energy source manually.
5.2 Switching on the refrigerator
Important! The memory of the SES system saves every change made to the setting.
Consequently, the SES system will start up on each subsequent occasion in the
last-selected setting.
ILLUSTRATION 7
A = Main switch (on/off)
B = Mode selection switch
C = Cooling level switch
D = Display LED
1. Open the valve of the gas bottle.
2. Open the taps of the gas supply.
3. Press main switch (A). The LED alongside the main switch will turn green.
4. Use the mode selection switch to select the “Auto” function or one of the power
supplies that you want. The LEDs will show the option you have selected.
5. Set the desired cooling level by means of the cooling level selection switch (C).
The LEDs will show the cooling level setting you have selected.
A. Use the main switch to switch the refrigerator on and off. The LED alongside the
main switch will turn green. The display LEDs show the most recent settings.
After 10 seconds the display LEDs will go out. The LED of the main switch
remains green.
B. Press the mode selector switch and the display LEDs will show the setting for 10
seconds. Successively pressing the mode selector switch takes you through the
menu in the following sequence: AUTO, manual DC (12 V), manual gas, manual
mains voltage (230 V) and back to AUTO. Select either the AUTO option or one
of the other power supplies that you want to use. The LEDs show the option you
have selected. If you select the AUTO option, the system will choose the most
suitable power supply and the AUTO LED and the LED of the power supply
chosen by the system will both light up. Ten seconds after release of the mode
selector switch, the system will switch off the LEDs. They will go out.
C. Use the cooling level selector switch to control the temperature of the
refrigerator. When you press the cooling level selector switch, the LED showing
the currently set temperature will light up. Every time you press the cooling level
selector switch you set the refrigerator one position cooler. On reaching the
coldest temperature, the system will start again at the warmest temperature
setting. Ten seconds after release of the cooling level selector switch, the system
will switch off the LEDs. They will go out.
5.3 Powering with electricity
Powering with electricity can be selected both by the Auto mode and manually.
5.3.1 Auto mode
Mains voltage (230 V):
This energy source will be selected if the mains voltage is greater than 200 V. This
power supply requires a continuous current of 12 V to operate the electronic
control system.
Direct current (12V) :
The SES system will select 12 V powering only if a mains voltage (230 V) is
- 7 -
6071_BW.qxd 24-06-2005 14:58 Pagina 7
5

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Thetford-N145

Zoeken resetten

  • Mijn koelkast werkt niet meer op gas, 12v en 230v. Koelt niet meer! Hoe kunnen we de ijskast resetten. Gesteld op 29-7-2020 om 00:17

    Reageer op deze vraag Misbruik melden
  • mijn koelkast start niet door op gas werkt wel op 12 en 220 volt vorig jaar duurde het heel lang voor hij wel op gas werkte. Gesteld op 19-3-2020 om 17:37

    Reageer op deze vraag Misbruik melden
  • wat is de functie van de tuimelschakelaar op de koelkast? Gesteld op 30-9-2017 om 23:20

    Reageer op deze vraag Misbruik melden
  • Zwart aan/uit knopje onderaan de tussenbalk vriezer en ijskast dient om? Gesteld op 9-3-2015 om 17:58

    Reageer op deze vraag Misbruik melden
  • Ik heb een vraag . Wie weet waar de schakelaar voor is die onder het bedieningspaneel van de koelkast ,N145 a ,zit? Dat staat niet in de gebruikers handleiding. Wie kan mijn helpen?
    Mijn email -adres is : inamul@hetnet.nl Gesteld op 11-11-2011 om 22:08

    Reageer op deze vraag Misbruik melden
    • Die is ervoor om een eventuele ventilator achteraf achter de rooster in te bouwen zodat bij warm weer de warmte sneller wordt afgevoerd zodat er een betere koeling is. met deze schakelaar kan je dan de ventilator aan of uit zetten Geantwoord op 27-10-2013 om 22:16

      Waardeer dit antwoord (23) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Thetford N145 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Thetford N145 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens, Zweeds, Noors als bijlage per email.

De handleiding is 2,68 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info