703889
3
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
Hang the center speaker on the wall using the keyholes and
the pre-installed screws.
These openings are also suitable for mounting on a wall
bracket.
Alternatively, you can also use the threaded hole on the bot-
tom of the speaker. The speaker is delivered with a screw in
the threaded hole, which you must twist out before mounting
the speaker.
You can nd corresponding speaker stands and wall brack-
ets in our webshop.
Setup
If you would like to set up the speaker,
afx the 4 enclosed rubber feet to the
corners on the bottom of the speaker.
This prevents noise created by vibra-
tions.
Connecting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
Pull the power plug for your AV receiver or multi-channel ac-
tive subwoofer out of the socket.
Lay the speaker cable from your AV receiver or multi-channel
active subwoofer to the speaker. Use a high-quality double
wire speaker cable with marked strands for this. The cross-
section should amount to at least 1.5 .
A connector terminal with two clips, which you have to
connect the speaker cable to, is located on the back of the
speaker.
The terminals are each marked red (+) and black ().
Make sure the polarity is correct!
Connect the like coloured terminals. The speaker
connectors of your AV receiver
or multi-channel ac-
tive subwoofer
should be marked similarly. The strands of the
speaker cables are marked with different colours or shapes.
1. Split the wire down by approx. 30 mm on both ends and
remove approx. 10 mm of insulation each.
2. Twist the stripped wire ends so that no strands are protrud-
ing. Tin coating is not necessary.
3. Turn the connector terminal counterclockwise until loose.
Run the stripped cable end into the now visible hole. Close
the terminal by turning it counterclockwise. The cable has
now been clamped in place.
4. Connect the speaker cable to your AV receiver or multi-chan-
nel active subwoofer. You should nd corresponding notes in
the operating instructions for your device.
Removing the protective grid
You can remove the protective grids by carefully reaching
behind them and slowly pulling them out to the front.
Removing the protective grid in particular will improve the
clarity of playback of high frequency sounds.
When installing the protective grid, please make sure that
the installation pins slide directly into the corresponding
jacks on the speaker.
Crossover frequency
We recommend a crossover frequency of 80–100 Hz. To the
extent possible, congure this setting on your AV receiver or
decoder station if they permit this particular setting.
Operation in full-range mode is also possible (all speakers
are set to “Large”). However, the maximum volume is slightly
lower then.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Teufel UL 40 C Mk2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Teufel UL 40 C Mk2 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info