649707
4
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
4
WARNING:DANGER!
Connect the mounting socket (Fig. A-1) to the starter’s
12V or 24V power supply, checking the voltage
required for the vehicle to be started, and only after
being absolutely certain that the clamps have been
connected to the battery polarities correctly.
- Connect the mounting socket following the instructions
above.
- Turn the ignition switch or key of the vehicle or boat to
ON. Wait about one minute. Turn the vehicle ignition
switch or key to the start position for no more than 5÷6
seconds. If the vehicle or boat does not start, wait at
least 3 minutes before trying again.
Warning: Do not allow the black and red
clamps to come into contact with each other
or to touch a common conductor.
- Whilst the engine is running, disconnect the mounting
socket from the starter and the clamps from the vehicle
in the exact order seen below:
1. the mounting socket.
2. the black (negative) clamp.
3. the red (positive) clamp.
- Return the clamps to their housing on the starter.
It is highly recommended to recharge the starter as
soon as possible!
Using the starter as a 12V power supply unit by
means of the cigar-lighter type socket (Fig. A-4).
WARNING!12VOUTPUTONLY!
In case of overload the re-settable safety
switch will trip. To restore operation, remove
the cause of overload and press the button shown
in Fig.A-2.
- Take the cover off the cigar-lighter type socket (Fig.
A-4).
- Insert the cigar-lighter plug of the device to be powered
into the socket (Fig. A-4).
Recharging using a 230V AC power supply
Important! To protect the battery and lengthen
its working life, charge it for 12 hours before
usingitforthersttime,thenaftereverytime
it is used and, in any case, at least every 3 months.
It is possible to recharge the unit using the 230V AC
power adapter supplied. We recommend keeping the
battery fully charged at all times. A low charge level could
shorten the life of the battery. Bear in mind that the time
needed to recharge the battery depends on the number
of times it has been used. It is possible to check whether
the battery level is low by pressing the red button (Fig.
A-5).
The voltmeter (Fig. A-3) will indicate the battery charge
level. The green area of the voltmeter indicates that the
battery is charged.
Recharging
1- Connect the free starter plug at POSITION 12V,
making sure that the starter clamps are positioned in
the relative pocket and insulated from each other.
2- Insert the car cigarette lighter plug supplied with the
battery charger into the starter outlet (Fig. A-4).
3- Insert the battery charger plug into a 230 V socket.
4- Allow the starter to recharge for as long as necessary
(refer to the battery charger user manual).
5- When charging is nished remove the battery
charger and disconnect the free starter plug from
POSITION 12V.
Pb
DISPOSING OF THE BATTERY
When the starter battery is completely run down it should
be taken to a re-cycling depot. In some countries this is
mandatory. Contact the local special refuse authority for
information on recycling.
WARNING: Do not burn the battery to dispose of it.
This could cause an explosion. Before disposing of the
battery, apply insulating tape to the bare terminals to
prevent shorting. Do not expose the battery to intense
heat or re as this could cause an explosion.
STARTER SPECIFICATIONS “4824”
Typeofbattery:
- rechargeable factory-sealed 12V acid-lead batteries.
Batterycapacity:
- 40Ah.
Outputcurrent@24V:
- 2200A peak current;
- 800A starter current.
Outputcurrent@12V:
- 4400A peak current;
- 1600A starter current.
Coppercables:
- PVC insulated 16mm
2.
Cablelength:
- 190cm.
Outputsocket:
- 12V DC / max. current 10A.
Generalfeatures:
- re-settable safety switch for output overload;
- automatic charging level reset switch;
- “cigar-lighter” type socket, 12V DC.
Weight:
- 24kg.
Standardaccessories:
-
T-CHARGE 12 Power supply / Battery charger (Fig. B).
STARTER SPECIFICATIONS “6824”
Typeofbattery:
- rechargeable factory-sealed 12V acid-lead batteries.
Batterycapacity:
- 40Ah - 80Ah.
Outputcurrent@24V:
- 3000A peak current;
- 1000A starter current.
Outputcurrent@12V:
- 6000A peak current;
- 2000A starter current.
Coppercables:
- PVC insulated 25mm
2.
Cablelength:
- 220cm.
Outputsocket:
- 12V DC / max. current 10A.
Generalfeatures:
- re-settable safety switch for output overload;
- automatic charging level reset switch;
- “cigar-lighter” type socket, 12V DC.
Weight:
- 39kg.
Standardaccessories:
-
T-CHARGE 12 Power supply / Battery charger (Fig. B).
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Telwin START PLUS 6824 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Telwin START PLUS 6824 in de taal/talen: Alle talen als bijlage per email.

De handleiding is 1,47 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info