622566
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
While green LED is still on, enter desired time-delay, whit 2 digit number ex. :
00 for no delay.
05 for 5 minutes time-delay.
20 for 20 minutes time-delay.
99 for 99 minutes time-delay.
If errors have been made while setting your new code, this will be indicated by the red “ERROR” LED
lighting up and a beep. Repeat the procedure for setting your new personal code again.
The code set before the incorrect procedure will remain in memory (for new safe “1111”).
Before finally closing the safe, it is advisable to check that everything is OK by operating
the opening and closing mechanism a number of times with the door open. Then shut the
door and turn the knob anticlockwise until it is closed
OPENING THE SAFE USING YOUR PERSONAL CODE
Enter your personal code set earlier and press “ENTER”. The green “OK” LED lights up for five
seconds. Within this time, turn the knob clockwise and open the door (if the time-delay is 00
minutes).
SIGNAL INDICATING THAT INTERNAL BATTERIES IS GOING FLAT
When the internal battery begins to go flat, this is indicated at the end of the opening procedure, by
the red “BATTERY” LED lighting up and a low beep tone. At this point, it will still be possible to open
the safe a number of times. Replace the internal batteries with 4 x LLR6 AA 1.5V alkaline batteries
EMERGENCY OPENING IN CASE OF BLACK-OUT AND/OR FLAT BATTERIES
In these cases , a new 9-volt LR61 alkaline battery will be necessary.
Press the 9-volt battery contacts firmly on the corresponding contacts on the keyboards, ensuring
that they are positioned correctly (the “-“ of the battery touching the bigger contact and the “+” of the
battery touching the small contact). With the battery firmly in position, key in code and open door.
Replace internal batteries immediately.
CAUTION
Replace the 4 x LLR6 AA 1.5 V alkaline batteries every year It must be remembered that even
new, packed batteries can sometimes be defective, for various reasons, or have a brief
duration. In the event of failure of the magnet release, or other faults, first of all, replace the
battery with a new 4 x LR6 AA 1.5 V alkaline batteries (DURACELL LR6 AA is recommended)
The manufacture declines all responsibility for failure to observe the instructions given, or for
improper use of the safe, thus causing the warranty to lapse.
Versions with EMERGENCY KEY
OPENING WITH EMERGENCY KEY
Remove the adhesive label marked with the letter “E” (see pic. 1).
Insert the key and open the lock up to the stop point.
Open the door.
Once the door is open, turn the knob anticlockwise until the bolts are fully extended.
Close the lock and remove the key.
WARNING!
NEVER LEAVE YOUR
EMERGENCY KEY IN THE SAFE
PIC.1
PIC. 3
VOLTAGE TRANSFORMER
JACK CONNECTOR
PROGRAMMING BUTTON
PIC. 2
Batteries case
TO BE REMOVED
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Technomax Trony GTR-6P bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Technomax Trony GTR-6P in de taal/talen: Engels als bijlage per email.

De handleiding is 0,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Technomax Trony GTR-6P

Technomax Trony GTR-6P Gebruiksaanwijzing - Nederlands - 2 pagina's

Technomax Trony GTR-6P Gebruiksaanwijzing - Français - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info