637111
58
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
I Problem Probable cause(s) t Suggested remedy I
Problems common to all systems
There is no sound when the Volume is set too low. Adjust the volume level with the volume control on
power is ON. the amplifier.
The location of the various The (+) and (-) connections to one of the Connect the speaker cords correctly.
musical instruments is not speakers are reversed.
well defined.
The left and right sounds The left and right connections to the speaker are Connect the speaker cords correctly.
are reversed, reversed.
When listening to the The left and right connections to the external unit Connect the external unit's cord correctly.
external unit, the left and are reversed.
right sounds are reversed.
Only one speaker is One of the wires of the speaker cord is Connect the speaker cord correctly.
emitting sound, disconnected.
The balance control is set to left or right. Set the balance to the center position.
There is no sound when a The (+) and (-) wire of the speaker cords are Switch the system to the standby mode, and
source is being played, shorted, reconnect the speaker cords so that they are not
shorted. Then switch on the power.
"UTO" display appears on Flat cables are not connected steadily. Connect the flat cables steadily.
the compact disc changer
or tunerlsound processor
display.
While listening to FM broadcasts
The transmitting station is a long distance away.There is a "rushing noise"
during a stereo broadcast
which is not audible during
a monaural broadcast.
You hear excessive noise
during a stereo broadcast,
and occasionally the sound
disappears.
The stereo indicator
flickers and does not light
completely.
The sound during a stereo
broadcast is highly
distored.
The installation location and orientation of the
antenna are unsuitable.
The transmitting station is a long distance away.
The power of the TV set or VCR is ON.
There is a building or mountain nearby. [Distortion
is caused by interference between the signal from
the transmitting station (direct wave) and the
signal reflected from the building or mountain
(reflected wave).]
elf you are using an indoor antenna, change to an
outdoor antena.
elf you are using a high-grade outdoor antenna, try
changing the installation location, height and
orientation.
Try switching off the TV set or VCR.
Use a high-grade outdoor antenna, and install it in a
good location, height and orientation for reception.
While listening to AM broadcasts
You hear an unusual beat You are using the system at the same time you Switch off the TV set, or use the system farther away
sound, are playing a TV set. from it.
You hear a low-frequency The antenna wire is near the power cord. Separate the antenna wire from the power cord.
hum.
58
58

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Technics-SC-CH515

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Technics SC-CH515 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Technics SC-CH515 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info