GB GBGB
54
TAKING WEIGHT AND BODY FAT READINGS
1. Select Personal Data Number
Press the Up button turn on. Use the Up/Down buttons to select
your Personal data number. Press the Set button to confirm.
(Release the key within 3 seconds or the display will show “Error”.)
The unit will beep and the display will show the programmed data.
The unit will beep again and the display will show “0.0”. Now
step onto the platform.
Note: •If you step onto the platform before “0.0” appears the display will show
“Error” and you will not obtain a reading. Furthermore, if you do not step
onto the measuring platform within about 30 seconds after “0.0” appears,
the power is shut-off automatically.
•When using the “Up” button to turn the unit on, the personal data
number last used will appear first.
•Numbers that are not pre-programmed are automatically skipped.
2. Get Your Readings
Your weight will be shown first.
Continue to stand on the platform.
"00000" will appear on the display and disappear one by one from
left to right.
The display will then flash your weight %FAT, %TBW and BMR alternately 3
times.
Note:Do not step off until Body Fat % is shown.
Note: For children (age 7-17), the unit will only display the Weight
and the Body Fat % (it will not display the Healthy Range
Indicator).
3. Recall Function
While readings flash (step.2), step off scale, press the SET button
to view previous reading.
Press the SET button again to go back to the current Weight and
Body Fat % result display.
PROGRAMMING THE GUEST MODE
TAKING WEIGHT MEASUREMENT ONLY
TROUBLESHOOTING
If the following problems occur ...then...
・A wrong weight format appears followed by kg, lb, or st-lb.
Refer to Switching the Weight Mode on p.2.
・"Lo" appears on the display, or all the data appears and immediately
disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will
affect the accuracy of your measurements. Change all the batteries at the same time with new batteries.
Note:Your settings will not be erased from the memory when you remove the batteries.
・"Error" appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
・The Body Fat Percentage reading does not appear or "-----" appears after
the weight is measured.
Your personal data has not been programmed. Follow the steps on p.3.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides
on the measuring platform.
・"OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
・No reading is obtained after pressing a feature key.
Step off scale when body fat reading appears, then press feature key.
Guest mode allows you to programme the unit for a one-time use
without resetting a Personal data number.
Press ▼ button to activate the unit. Then follow the
steps: Set Age, Select Female or Male, and Specify Height.
Note : If you step onto the platform before “0.0” appears the display will show
“Error” and you will not obtain a reading.
Select Weight-Only Key
Press the Weight-only key. After 2 or 3 seconds, “0.0” will appear
in the display and the unit will beep. When “0.0” appears in the
display, step onto the platform. The body weight value will appear.
If you remain on the platform, the display will flash for about 30
seconds, and then the power will automatically turn off. If you step
off the platform, the weight will continue to show for about 5
seconds, then “0.0” will appear and the unit will shut off
automatically.
