658284
4
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
4 MIC MECHANIC 2 User Manual
Connection
Connect a microphone to the MIC jack
Connect the OUT jack to a mixer, interface or active speaker
Connect the power cable (optional)
Connect a micro USB cable to a computer (optional)
Tap Tempo
The echo tempo can be manually adjusted to match the song you’re performing.
Simply hold the Footswitch down for about 2 seconds to enter Tap Mode. The
on/o LED will  ash in rhythm with the current tempo. Tap the footswitch a few
times in rhythm with your desired tempo, and on the last tap, hold your foot on
the switch for around 2 seconds to exit Tap Mode.
Note – the pedal will not “time out” of Tap Mode, so you can keep this mode
active if you intend to leave the e ect on throughout a song or set, allowing you
easier access to this function.
Adjusting Echo Feedback
Feedback is the parameter that controls how many repeats are heard in the
echo e ect. By holding the Tone button and turning the Correction knob, you
can adjust the feedback length. As soon as you release the Tone button, the
Correction knob will resume its normal function.
Changing the Batteries
The Mic Mechanic 2 can operate on 4 AA batteries. Remove the single screw on
the bottom of the pedal to open the battery door. Make sure to observe correct
polarity when inserting the batteries.
Auto Gain
Mic Mechanic 2 will automatically adjust the gain setting for your microphone,
eliminating the need for manual adjustments and ensuring that a good signal is
passed to the mixer without any unwanted distortion.
24V Phantom Power
Phantom power is always active on the Mic Mechanic 2. This will power
condenser microphones, but will not a ect dynamic mics either.
Mic Control
Mic Control allows you to control the e ect's on/o status via an MP-75
microphone. Press and hold the footswitch while powering up the unit to
toggle Mic Control.
Note that when using a condenser microphone, Mic Control should be disabled
to prevent unwanted on/o switching.
Micro USB cable
MP-75 microphone
Mixing board
Power cable
2. Operation
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw TC Helicon Mic Mechanic 2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van TC Helicon Mic Mechanic 2 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,97 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info