6.3.4 BRAKE ADJUSTMENT
If the braking distance lengthens, the
brake will need adjusting.
The adjustment will need to be made with
the parking brake ENGAGED.
1. Remove the collector channel (1),
which is fixed by a pin (2) and split pin
(3);
2. turn the adjusting nut (4) (which is
reached by taking off the engine cover)
until there is a distance of 86-88 mm
between the bracket (5) and the upper
part of the lever (6).
3. refit the collector channel (1) and put
the pin (2) and split pin (3) back in
place.
If the brake still does not work properly even after this
adjustment, immediately contact the Licensed Service Centre. DO NOT
ATTEMPT ANY OTHER WORK ON THE BRAKE THAN WHAT IS
DESCRIBED HERE.
6.3.5 A
DJUSTING THE TENSION OF THE DRIVE BELT
If you should notice that forward drive power
has dropped, it will be necessary to adjust the
spring of the stretcher. Make the adjustment
with the parking brake DISENGAGED (to make
sure that the machine does not move) and with
the cutting deck in position «3».
1. Remove the collector channel (1), fastened
by a pin (2) and the split pin (3);
2. check that the cap (4) of the engagement
cable is fitted firmly in its correct position;
3. turn the nuts (5) until the spring (6) reaches a
total length of 174 - 176 mm measured from
the outer ends of the eyelets;
!
WARNING!
EN 32 MAINTENANCE
