622131
5
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
8 9
2. If the unit detects that the alternator is good, the LCD screen will display the following:
The pump engine icon will light solid, and the bars on the battery icon will change from empty to solid (bottom to top)
repeatedly.
3. If the unit detects that the alternator is out of typical voltage range, the LCD screen will display the following:
The half-full battery icon will light solid and the triangular alarm icon will flash.
4. Press the alternator check button again to stop the test.
Notes:
The battery voltage check button is disabled in alternator check mode.
The unit may detect that the alternator is out of typical voltage range because someone has added a number of accessory loads on the charging system,
thereby increasing current demand from the alternator. MAKE SURE THAT THE ALTERNATOR IS RATED TO SUPPORT THE APPLICATION.
This check may not be accurate for every make, manufacturer and model of vehicle. Check only 12 volt systems.
When disconnecting the charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery terminal.
Checking the Battery Voltage
1. Set up the battery charger and connect to the battery following steps 1 through 2 in the “Charging the Battery section.
2. Press the battery voltage check button. The LCD screen will display the following:
The digital display shows the current voltage of the connected battery.
To check the battery voltage while in charging mode, press the battery voltage check button and the LCD screen will display the
following:
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery
terminal.
Reconditioning the Battery
Periodic reconditioning is recommended to maintain a batterys optimum performance. Battery recondition sends a series of
electrical pulses to break up the crystalline form of lead sulfate and turn these chemicals into useful battery electrolytes. The
process will stop automatically after 24 hours. To stop the process sooner, press the battery recondition button a second time. More
than 24 hours may be needed to restore performance on some batteries. If so, repeat the process.
1. Set up the battery charger and connect to the battery following steps 1 through 2 in the “Charging the Battery section.
2. Press the battery recondition button. The LCD screen will display the following:
The bars on the battery icon will change from solid to empty (top to bottom) repeatedly and the icons pointing to the “+” and
“–” flash.
IMPORTANT: If 5 cycles of reconditioning does not improve battery performance, discontinue and recycle the battery.
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery
terminal.
Using the Engine Start Timer (BC1509)
1. Set up the battery charger and connect to the battery following steps 1 through 2 in the “Charging the Battery section.
2. Press the engine start timer button. The LCD screen will display the following*:
IMPORTANT: If the charger detects a problem with the battery, the LCD screen will display the fault indication icon (the clamp
icon will light and the empty battery icon will flash):
Disconnect the charger. Have the battery checked by a qualified technician.
4. BC1509: When the battery is completely charged, the unit automatically goes into float charge mode and the LCD screen
displays the following:
The digital display shows “FLO” to indicate that the unit is in float charge mode. The battery fully charged icon will display on
the LCD screen and the arrows pointing to the “+” and “-” will flash. In this mode, the unit monitors the battery voltage and
charges as necessary to assure the battery maintains full capacity. The unit remains in float charge mode as long as the charger
is connected to the battery and plugged into a functioning AC outlet.
BC2509 and BC4009: When the charging is complete, the arrow and clamp icons and digital display stop displaying. The
battery fully charged icon will display on the LCD screen:
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery
terminal.
Using the Alternator Check Function
Set up the battery charger and connect to the battery following steps 1 through 2 in the “Charging the Battery section.
Par t 1
No Load (turn OFF all vehicles accessories): The battery must be fully charged before testing the alternator. Run the engine long
enough to achieve normal idle speed and verify there is a no-load voltage.
1. Press the alternator check button to start the check. The LCD screen will display the following to indicate the unit is analyzing
the alternator:
The pump engine icon and the half-full battery icon will flash.
2. If the unit detects that the alternator is good, the LCD screen will display the following:
The pump engine icon will light solid, and the bars on the battery icon will change from empty to solid (bottom to top)
repeatedly.
3. If the unit detects that the alternator is out of typical voltage range, the LCD screen will display the following:
The half-full battery icon will light solid and the triangular alarm icon will flash.
4. Press the alternator check button again to stop the test.
Par t 2
Under Load (accessories ON): Next, load the alternator by turning on as many accessories as possible (except for A/C and Defrost).
1. Press the alternator check button to start the check. The LCD screen will display the following to indicate the unit is analyzing
the alternator:
The pump engine icon and the half-full battery icon will flash.
BC1509_2509_4009_ManualENSP_032213.indd 8-9 4/30/2013 6:21:00 PM
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Stanley BC1509 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Stanley BC1509 in de taal/talen: Engels, Spaans als bijlage per email.

De handleiding is 1,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info