552580
2
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
OPERATING INTRUCTIONS
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, micro lming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.
Version 11/12
TV wall holder 81-160 cm (32-63”), inclinable
Item no. 98 92 73
Intended use
The TV wall holder is used for the installation of suitable TV sets on walls.
The TV set may not exceed the values for TV size and weight indicated in the section “Technical Data”.
Any use other than described above may lead to damage of this product or the TV set and furthermore, brings
about risks such as damage to furniture in the proximity of the wall holder, personal injury etc.
No part of the product may be modi ed or altered.
The safety instructions must be observed at all times.
Package Contents
See image 1 on the insert sheet included in these operating instructions.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We will not assume liability for any resulting damage.
We shall not accept liability for damage to property or personal injury caused by incorrect
handling or non-compliance with the safety instructions! In such cases, the warranty will
be null and void.
The exclamation mark symbol indicates important information in these operating instruc-
tions.
The symbol with the arrow indicates tips and notes
A TV wall holder is not a toy. Keep the device out of the reach of children.
Do not leave packaging material lying around carelessly. It may become a dangerous toy for children.
Selecting an unsuitable installation location can lead to personal or material damage.
Proceed with care when assembling and installing the product. The product may have some sharp edges.
There is a risk of injury!
Carry out only the work on the TV holder that is necessary in order to install it (or to adjust it). Never perform
any modi cation, conversion or repair work.
Before beginning the installation process, check whether there are appropriate mounting options for a TV
wall holder on the back of your TV set.
Depending on the size and design of the TV set and TV wall holder concerned, it is sensible for a second
person to help with the installation. This person should hold the TV set, for example, while you attach the
TV set to the wall bracket.
Apply your full concentration when carrying out the installation, because if the TV set and/or the TV holder
were to fall, this not only could cause expensive damage to the equipment but there is also the potential
danger of personal injury!
Lay all the TV set’s cables in such a way that they do not get jammed or kinked in the wall holder.
Check all the screw ttings from time to time. Adjusting the position of the TV set and/or the TV holder and
moving them can sometimes cause the screws to become loose over time.
Do not apply force when moving/adjusting the TV set or the TV wall bracket. The TV set may get damaged
from it.
When moving/adjusting, do not press on the TV’s screen.
Do not overload the TV wall holder. Pay attention to the details provided by the manufacturer for the TV set’s
maximum weight and/or its size.
Do not use the TV wall holder to support yourself or to hold onto.
Do not fasten any objects on the TV wall holder other than the TV set intended for this purpose.
If you are in doubt, do not carry out the installation yourself. Let a skilled expert carry out the installation.
Installation
Wall-mounting is permissible only where the wall concerned is of the correct type and
condition. Lightweight partition walls or those made from gypsum boards are normally
unsuitable. However, specialist retailers do sometimes stock special dowel ttings for
such installation locations. If you are in doubt, ask a specialist before installation.
Depending on the base wall material (e.g. concrete), suitable mounting materials must be
used (screws, dowels, etc.). The plug screws enclosed are only suitable for solid walls.
Special dowels and screws are not supplied with the TV wall holder and must be pur-
chased separately and according to the wall type and condition.
Due to the weight of the TV set and TV holder and the lever action involved, ensure that
screws are xed securely.
Choose the mounting location carefully so that, after completion of the installation, the TV
wall holder with the TV set attached to it are located at the desired location (height and posi-
tion).
Pay attention when drilling and tightening the screws that no cables or pipes inside the
wall are damaged. Inadvertently drilling through electric cables causes the life-threatening
danger of an electric shock!
Pay special attention to your safety when using electric tools (e.g. a drill). You should also
heed the safety instructions of the corresponding user manuals.
Ensure that no persons are in the area under the TV wall holder or the TV set while carrying
out the installation.
Please take note of the illustrations and images on the insert sheet of these operating instruc-
tions.
Preparation of the TV set
It is usually necessary to remove the TV set’s base before mounting the TV on a TV holder. Observe the
operating instructions for your TV set.
Place the TV set at on a soft and clean underlay, the display facing downwards. Do not apply any pressure
on the display. Protect valuable furniture surfaces during installation by using a suitable underlay.
Remove the present base. Depending on the TV set, the base might be bolted down or clipped in.
Image 2
Choose the position and height for the attachment frame at the installation location.
Align the attachment frame horizontally using a water level.
Mark the eight necessary drilling holes on the mounting surface. The upper rail of the attachment frame
must be tightened with six screws, the lower rail with two screws. To mark the holes on the surface, use the
attachment frame as a template.
Drill the required holes and use suitable dowels for the drilled holes.
Screw down the attachment frame using suitable screws and washers, as shown in the image.
Image 3
Attach the two mounting brackets to the rear of your TV set using suitable screws and washers. Proceed as
shown under a and c.
When mounting the brackets, keep in mind, that the knurled screws on the brackets must point towards the
TV’s upper side.
When xing the mounting brackets, make absolutely certain that you use the correct
screws. Not only must these be of the correct thread type for the TV set, but they must also
not be too long; otherwise they will damage the TV set.
The screws must not be too short either otherwise the connection will not be secure. The
screws must be screwed into the corresponding threaded xture holes on the TV set with
at least 5 full 360° turns.
If the length of the screws in the screw set enclosed are not suitable for your TV set, please buy
suitable screws at your local hardware store.
If you have any doubt about the correct length of the screws required, we recommend that
you contact the TV manufacturer or an appropriate specialist.
Do not use any force when tightening the screws; otherwise the TV set may be destroyed, leading to loss
of warranty/guarantee!
If your TV set has a curved back side, or if for any other reason, you need to increase the distance to the
wall, you can insert the grey spacers included in the screw set between TV set and mounting brackets, as
shown under b.
Fasten the knurled screws used for the inclination adjustment on the brackets in order to x the mechanism
during installation.
Image 4
Place the TV set with the mounted brackets from above onto the attachment frame, as shown under a.
The catches of the mounting brackets have to lock in place perfectly and smoothly in the attachment frame’s
pro le.
Adjust the TV set so that it is located in the middle of the frame.
Push the safety plates on the lower catches upwards, as shown under b, and bolt them down so that the TV
set is secured on the attachment frame.
Now adjust the desired inclination angle, as shown under c, using the two knurled screws.
Maintenance and Care
The product does not have to be serviced and, except for occasional cleaning with a soft, dry cloth, requires
no maintenance whatsoever.
Never use aggressive cleaning agents or chemical solutions as these may damage the surface of the case.
Technical Data
TV size .........................................81-160 cm (32-63”)
Load carrying capacity .................max. 75 kg
VESA attachment ........................max. 600 x 400
Wall distance ...............................79 mm
Material ........................................ steel
OPERATING INTRUCTIONS
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Speaka 989273 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Speaka 989273 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info