GB - 8
RADIO OPERATION
1. Press RADIO ON/BAND button once to turn on radio power, RADIO will
light up on the LCD.
2. Press RADIO ON/BAND button again to select radio band.
3. PresstheTUNE/TIMEbutton+or–momentarily(lessthan0.5sec.)tostepupordownthereceiving
frequency in order to select the desired station.
4. Forautotuning,keeppressingtheTUNE/TIMEbutton+or–(morethan0.5sec.)untilthedisplayed
frequency starts to change, then release the button. Tuning will stop automatically when a station is
received.
5. AdjustthesoundlevelbypressingVOLUME+/–buttons.
6. To turn the unit off after use, simply press STOP/OFF button once.
NOTE: After radio frequency is displayed for about 10 seconds, the LCD will show the current time.
Pressing the RADIO ON/BAND button once will show radio frequency again.
Improving the reception
• Extend the FM wire antenna which is located on the back of unit, and change its position until the
best FM reception is found.
• The unit has a built-in ferrite bar antenna for AM radio reception. Check the condition of AM reception
beforexingthisunitinposition.
• Install the unit as far as possible from a source of noise. (for example : refrigerator, microwave oven,
uorescentlamp,etc.)
PRESET STATIONS
1. Press the RADIO ON/BAND button to the desired band.
2. When the desired station is tuned, press CD MODE / PROGRAM button
to enter saving mode.
3. ThepresetlocationwillashontheLCD,pressPRESET / button
to select preset channel.
4. Press CD MODE / PROGRAM button again to save into memory. If it has previously set, the former
station is replaced.
5. Repeat step 1 ~ 4 to store more preset stations.
NOTE: The preset memory can store a maximum of 12 stations for FM band and 12 stations for AM
band.
RECALL A PRESET STATION
To recall any preset stations within the selected band, simply press the PRESET / buttons until
the preset radio frequency appears on the display.
TIMER OPERATION (Count-down timer)
• TIMER SETTING
- PressTIMERADJUST+or–todesiredcount-downtime,themaximum
count-down time is 120 minutes, with a 1 minute interval selection.
- Press the TIMER button once to start counting, the timer indicator will
light up.
- When the timer has been set and is counting, the LCD will show the count-down, however, current
time, radio frequency and CD playing track can also be displayed by pressing:
1. CLOCK button once to show current time and CD playing track when unit is in CD play mode.
2. CLOCK button once to show current time when unit is in radio on mode.
3. RADIO ON/BAND button once to show current radio frequency when unit is in radio on mode.
4. CLOCK button once to show current time when unit is in stop/off mode.
• About 5 seconds later, LCD will resume to show timer count-down.
- To cancel timer operation, simply press TIMER button once, the timer indicator will turn off.
- When desired time has elasped, refer to below section for details.
