36159
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
Listening to the radio
1 Press RADIO ON to turn on the radio.
2 Press BAND until the band you want appears.
Each time you press the button, the display changes as
follows:
t FM t AM t TV t WB
3 Press TUNE + or – (. or > on the remote
control) to tune in the station you want and adjust the
volume.
Tuning mode and Preset mode
To switch the tuning mode and the preset mode, use
P MODE/
.
When the preset number appears in the display, the CD
player is in the preset mode and you can use PRESET + or
– to select the preset number.
To enter the tuning mode, press P MODE/
to make the
preset number disappear from the display. Use TUNE + or
– (. or > on the remote control) to tune in the
station.
To turn off the radio
Press x•RADIO OFF. (Press and hold x•RADIO ON/
BAND•RADIO OFF on the remote control.)
To tune in the station quickly
Press and hold TUNE + or – in step 3 until the frequency
digits begin to change in the display. The CD player
automatically scans the radio frequencies and stops when
it finds a clear station.
To improve broadcast reception
For TV/WB/FM, extend the headphones cord.
For AM, reorient the CD player itself.
Note
Keep the headphones connected to the i jack of the CD
player. The headphones cord works as the FM/TV/WB
antenna.
If it is hard to hear the FM broadcast
Press and hold PLAY MODE/ until “LOCAL” appears
in the display.
Under the normal conditions, press and hold
PLAY MODE/
until “LOCAL” disappears from the
display.
When listening to the radio on batteries
If you connect the external power source plug to the DC
IN 4.5 V jack of your CD player, the CD player will turn
off. Turn it on by pressing RADIO ON to continue
listening to it.
Presetting radio stations
You can preset up to 51 stations: 30 for FM, 10 for AM, 7
for TV, and 4 for WB.
1 Press RADIO ON to turn on the radio.
2 Press BAND to select the band.
3 Press TUNE + or – (. or > on the remote
control) to tune in the station you want.
4 Hold down MEMORY until “PRESET” flashes in the
display.
From this step on, start the next operation within 30
seconds after you finished the previous operation. If
30 seconds pass with nothing done, “PRESET” stops
flashing which shows that the CD player has exited
the PRESET MEMORY standby mode. If this
happens, start from step 4 again.
5 Press PRESET + or – repeatedly to select the preset
number you want to store the station on while
“PRESET” flashes.
6 Press MEMORY.
When the station is preset successfully, the beep
sounds and “PRESET” stops flashing in the display.
The new station replaces the old one.
To preset another station, press PLAY MODE/
and repeat steps 2 to 6.
To exit the PRESET MEMORY standby
mode
When the radio is turned on, you can exit the PRESET
MEMORY standby mode using one of the following
procedures. Preset stations, however, will remain stored in
the CD player’s memory.
Hold down MEMORY until “PRESET” stops flashing.
Do not press any button for 30 seconds. “PRESET”
stops flashing.
Press x•RADIO OFF. (Press and hold x•RADIO ON/
BAND•RADIO OFF on the remote control.) The radio
turns off.
To cancel all preset stations
1 Disconnect the power source (alkaline batteries, AC
power adaptor).
2 While you press and hold down MEMORY, insert
alkaline batteries or connect the AC power adaptor
again.
The indications in the display keep flashing until all
preset stations are cleared, then stop flashing and
disappear from the display.
Playing preset radio
stations
1 Press BAND to select the band.
2 Switch your CD player to the preset mode*, then
press PRESET + or – to tune in a stored station.
*For details, refer to “Tuning mode and Preset mode.”
Other functions
You can make the following settings using the menu.
The timer function
*
1
You can set the CD player to stop playback automatically
within a range of 5 to 95 minutes at 5 minute intervals.
When the CD player is playing and the timer function is
activated, the track number flashes on the display.
The G-PROTECTION function
This function has been developed to provide excellent
protection against sound skipping during many active uses.*
2
Turning off the beep sound
You can turn off the beep sound that is heard from your
headphones/earphones when you operate your CD player.
Changing the tuning interval
When using the CD player abroad, change the AM tuning
interval, if necessary.*
3,
*
4
9 kHz area: Asia and Europe
10 kHz area: the U.S.A., Canada and South America
*1 When listening to the radio, this function does not work.
*2 Sound may skip:
if the CD player receives stronger continuous shock than
expected,
if a dirty or scratched CD is played or
when using poor-quality CD-Rs/CD-RWs or if there is a
problem with the recording device or application
software.
*3 The interval will not change until you turn off the radio
once and then turn it on again.
*4 After changing the tuning interval, you need to preset radio
stations again.
How to set
1 While play is stopped, press DISPLAY/MENU until
“t-SEt” appears.
From this step on, start the next operation within 15
seconds after you finish the previous operation. If the
indications on the display disappear, start from step 1
again.
2 Press . or > to select the Menu 1 item, then
press DISPLAY/MENU or u.
Menu 2 item starts flashing.
3 Press . or > to select the Menu 2 item, then
press DISPLAY/MENU or u to enter the selection.
When the item has been entered properly, the item
stops flashing.
To return to the previous screen, press x.
To cancel the setting operation, press and hold x.
List of menus
Setting Menu 1 , Menu 2
Timer* t-SEt – –
05
:
:
95
G-PROTECTION SEt on
off
Turning off the bEEP b on
beep sound b off
Changing the tuning StEP AM 9kHz
interval AM 10kHz
* You can set this item during both play and stop. When
listening to the radio, this function does not work.
The time set is estimated.
Note
If you disconnect the power sources, all settings return to
the defaults.
Precautions
On safety
Should any solid objects or liquid fall into the CD
player, unplug it and have it checked by qualified
personnel before operating it any further.
Do not put any foreign objects in the DC IN 4.5 V
(external power input) jack.
On power sources
When you are not using the CD player for a long time,
disconnect all power sources from the CD player.
On AC power adaptor
Use only the AC power adaptor supplied. If your CD
player is not supplied with it, use the AC-E45HG AC
power adaptor. Do not use any other AC power adaptor.
It may cause a malfunction.
Polarity of the plug
Do not touch the AC power adaptor with wet hands.
Connect the AC power adaptor to an easily accessible
AC outlet. Should you notice an abnormality in the AC
power adaptor, disconnect it from the AC outlet
immediately.
This warranty is valid only in the United States.
Headphones or
earphones
On dry batteries
Do not throw the batteries into fire.
Do not carry the batteries with coins or other metallic
objects. It can generate heat if the positive and negative
terminals of the battery are accidentally contacted by a
metallic object.
Do not mix new batteries with old ones.
Do not use different types of batteries together.
When the batteries are not to be used for a long time,
remove them.
If battery leakage occurs, wipe off any deposit in the
battery compartment, and install new batteries. In case
the deposit adheres to you, wash it off thoroughly.
On the CD player
Keep the lens on the CD player clean and do not touch
it. If you do so, the lens may be damaged and the CD
player will not operate properly.
Do not put any heavy object on top of the CD player.
The CD player and the CD may be damaged.
Do not leave the CD player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or sand, moisture, rain, mechanical
shock, unleveled surface, or in a car with its windows
closed.
If the CD player causes interference to the radio or
television reception, turn off the CD player or move it
away from the radio or television.
Discs with non-standard shapes (e.g., heart, square, star)
cannot be played on this CD player. Attempting to do so
may damage the CD player. Do not use such discs.
On headphones/earphones
Road safety
Do not use headphones/earphones while driving, cycling,
or operating any motorized vehicle. It may create a traffic
hazard and is illegal in some areas. It can also be
potentially dangerous to play your headsets at high
volume while walking, especially at pedestrian crossings.
You should exercise extreme caution or discontinue use in
potentially hazardous situations.
Preventing hearing damage
Avoid using headphones/earphones at high volume.
Hearing experts advise against continuous, loud and
extended play. If you experience a ringing in your ears,
reduce volume or discontinue use.
Consideration for others
Keep the volume at a moderate level. This will allow you
to hear outside sounds and to be considerate to the people
around you.
Maintenance
To clean the casing
Use a soft cloth slightly moistened in water or a mild
detergent solution. Do not use alcohol, benzine or thinner.
To clean the plugs
If the plugs become dirty, there is no audio or noise is
heard. Clean them with a dry soft cloth periodically.
Troubleshooting
Should any problem persist after you have made these
checks, consult your nearest Sony dealer.
“Hold” appears in the display when you
press a button, and the CD does not
play.
c The buttons are locked. Slide HOLD back.
The volume does not increase even if
you press VOL + repeatedly.
c Press and hold SOUND until “AVLS” disappears from
the display.
The battery compartment lid is
dettached by an accidental drop,
excessive force, etc.
c Attach it as illustrated below.
Specifications
System
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wavelength: l = 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW (This output is the value
measured at a distance of 200 mm from the objective lens
surface on the optical pick-up block with 7 mm aperture.)
Frequency range (10k/9k)
10 kHz step:
TV: 2 - 13 ch
WB (weather band): 1 - 7 ch
FM: 87.5 - 108.0 MHz
AM: 530 - 1 710 kHz
9 kHz step:
TV: 2 - 13 ch
WB (weather band): 1 - 7 ch
FM: 87.5 - 108.0 MHz
AM: 531 - 1 710 kHz
Power requirements
Two LR6 (size AA) batteries: 1.5 V DC × 2
AC power adaptor (DC IN 4.5 V jack):
220 V, 50 Hz (Model for China)
120 V, 60 Hz (Model for Mexico)
Dimensions (w/h/d) (without projecting
parts and controls)
Approx. 135,8 × 24.3 × 135.8 mm (5
3
8
×
31
32
× 5
3
8
in.)
Mass (excluding accessories)
Approx. 191 g (6.8 oz)
Operating temperature
5°C - 35°C (41°F - 95°F)
Design and specifications are subject to change without
notice.
Supplied Accessory
Headphones/earphones with remote control (1)
For the area code of the model you purchased, check the
upper left side of the bar code on the package.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sony DFJ200 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sony DFJ200 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,59 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info