680841
35
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
Troubleshooting
34
Fault Possible cause Remedial action
Operator does not close door
Drive opens gate but then no further reaction
to a command given via push-button or
remote controller
The drive closes the door; subsequently no
response to pressing of button or radio
transmitter
Connected warning light does not light up
Opening or closing speed varies
Operator does not terminate 'Learn' sequence
Only marathon!!
Door can only be operated if the external
push-button e.g. interior switch, key switch is
kept depressed - at the same time the interior
lighting flashes (dead man mode)
"Start" LED is continuously on
Only in units with radio receiver!
All LEDs are flashing
LED 3.1 or 3.2 is continuously on
LED 3.1 or 3.2 is on
Power supply to photoelectric cell
interrupted.
Power supply to drive interrupted
Safety input tripped
(e.g. photocell defective)
Safety LED is lit (only marathon)
Automatic close mode activated,
(marathon only)
"Door CLOSED" limit switch in the
trolley defective
"Door OPEN" limit switch in the trolley
defective
Fuse defective
Bulb defective
Operator starts slowly and then picks
up speed
Chain rail dirty
Chain rail lubricated with unsuitable
oil
Incorrect chain tension
End positions set incorrectly
'Dead man' mode activated
Continuous signal on button
connection 1 or 2.
Radio signal is being received; a
remote control transmitter button might
be defective or an external signal is
received.
All memory positions are occupied
(max. 112)
Radio signal is being received;
remote control transmitter button might
be defective or an external signal is
received.
Radio receiver is in 'teaching' mode
and expects a code signal from a
remote control device.
Check connection
replace fuse
The first command issued after restoration of the mains supply
results in the drive opening the gate fully.
- Remove obstacle from light barrier
- Repair photoelectric cell
- Socket unit not plugged in correctly (only sprint and duo)
Door closes automatically after expiration of the set time
Deactivate automatic close mode
Replace limit switch
Replace limit switch
Replace fuse, see 'Maintenance and Care' section
Replace bulb; see 'Maintenance and Care' section
'Soft run' mode - completely normal
Clean rail and re-lubricate,
see chapter 'Maintenance and care'
Clean rail and re-lubricate,
see chapter 'Maintenance and care'
Tighten chain; see 'Installation sprint / marathon' or Installation -
duo' section
Adjust end positions (see general instructions in "Commissioning")
Deactivate 'dead man' mode; see TorMinal instructions
Check connected buttons (e.g. key-activated button, if connected)
- Remove battery from the remote control transmitter
- Wait until the external signal decays
- Delete all radio control devices no longer in use
- Install additional radio receiver
- Remove battery from the remote control transmitter
- Wait until the external signal decays
Press desired button on remote control transmitter
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sommer Duo 500SL bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sommer Duo 500SL in de taal/talen: Engels als bijlage per email.

De handleiding is 4,66 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Sommer Duo 500SL

Sommer Duo 500SL Gebruiksaanwijzing - Nederlands - 40 pagina's

Sommer Duo 500SL Gebruiksaanwijzing - Deutsch - 37 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info