502155
6
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
10
11
WIRING CONNECTION
Cautions:
To prevent short circuits, remove the key from the ignition and disconnect the •
terminal of the battery.
Make the proper input and output cable connections for each unit.•
Connect the wiring harness cables in the following order: ground wire, battery wire, •
ignition wire.
Reconnect the terminal of the battery. •
Do not connect the yellow wire of this product directly to the battery terminal.•
Do remember to connect the red wire of this product to the ACC. of the ignition key •
switch. Failure to do may result in draining o the battery charge prematurely.
If the fuse blows, rst make sure that the cables have not caused a short circuit, then •
replace the old fuse with new one with the same rating.
Do not let unconnected cables or terminals touch the metal on the car or other •
conductor.
To prevent short circuits, do not remove the caps form unused terminals or from the •
ends of the unconnected cables.
After the monitor unit is installed, check whether the brake lamps, blinkers, wiper, •
etc. on the vehicle are working properly. If not, please make sure they are proper
installed.
Insulate unconnected wires with vinyl tape or other similar material. •
Disconnecting the Battery
To prevent a short circuit, be sure to turn o the ignition and remove the negative (-)
battery cable prior to installation.
Reconnecting the Battery
When wiring is complete, reconnect the battery negative terminal.
Warning:
Be sure to use the correct type and amperage Fuse to avoid damaging the unit.
Fuse of the Battery wire in Main Unit: 15 amp;
Fuse of the ACC wire in Main Unit: 2 amp;
FUSE REPLACEMENT – WARNING!
Never replace any fuse with one of a higher value than the fuse supplied
with your unit. Using a higher current rated fuse may cause damage to your unit
and/or electrical wiring.
HAND BRAKE SAFETY CABLE – WARNING!
This device is equipped with a safety feature that prohibits viewing of
moving pictures whilst the vehicle is in motion.
The Pink safety wire (Brake) on the systems own loom must be connected to the
vehicles hand brake system (ground active).
WIRING DIAGRAM
6

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Snooper-AVN-S7000

Zoeken resetten

  • ik ben in het bezit van een snooper S7000. E MARK: E11 10r-024992 met code N81B5745 wil deze weer laten updaten. maar waar ik dit altijd kon doen was in de buurt van Lieshout. maar krijg daar geen contact meer. Ben ook in het bezit van een camper en daar staan alle stelplaatsen dus ook in. graag info op wim@ak.nl bij voorbaat dank.
    Wim Arts. 0485573592. Gesteld op 25-9-2020 om 12:54

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Snooper AVN S7000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Snooper AVN S7000 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,39 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info