133128
6
Verklein
Vergroot
Pagina terug
1/22
Pagina verder
English
Installation
To fix the cooker hood please choose one of
the following options:
a) Fix it to the upper part of the furniture
Figure 3 must be used where the position
of the holes is indicated.
b) Fix it to the internal laterals of the
furniture:
1.- Screw two screws to each side of the
furniture interior following figure 5
instructions. Leave them 3 mm loose for
adjustment.
2.- Screw the provided brackets to the top
part of the hood, keeping the internal
furniture width.
3.- Hold and rise the hood until the slots of
their brackets fit in the screws (step 1)
of the furniture.
4.- Keeping the appliance hold, push it
towards furnitures bottom until screws
fits into a stable position inside the slots.
5.- Rise the hood a little until a definitive
position is obtained and tight the loosen
four screws to the brackets.
The lower part of the extractor must be
installed a minimum height of 60 cm
above the hob for electric cookers and 65
cm for gas cookers. (If the installation
instructions of a gas cooker indicate a
greater distance this must be observed).
The KSET910X cooker hood only can be
installed in furniture of 90 cm.
Once the hood is installed, the front facia
can be fitted. For this the frontal surface of
the hood is firstly cleaned with alcohol
(manufacturers safety recommendations for
the handling of solvents are always to be
followed). Then remove the protective paper
of the adhesive on the fascia, it can now be
placed in its correct position, applying
pressure on the adhesive area.
When the extractor is working at the same
time as other non-electrical cooking
equipment, the outlet air pressure must not
exceed 4 Pa (4 x 10
-5
bar).
To achieve optimum performance the length
of the outlet hose should not exceed 4
meters, or include more than two 90º angles
(elbows)
Although venting to the outside is
recommended, active carbon filters may be
used, which allow the purified air to be
returned to the kitchen through the outlet
pipe.
If you wish to substitute the front panel and
replace it with one matching the kitchen
units, follow the following instructions (Fig.2):
* Withdraw the movable group.
* Remove the screws (T) that support the
front.
* Install the new front fixing it with the same
screws that held the old one.
If something does not work
Before seeking technical assistance carry
out the following checks first:
Om någonting inte fungerar
Innan du kontaktar verkstad gå efter följande
instruktioner:
FEL MÖJLIG ORSAK LÖSNING
Kontakten är inte isatt Sätta i kontakten
Fläkten fungerar inte
Det kommer inte ström i
kontakten
Försäkra dig om att det finns el
Filtret är fullt med fett Rengör filtret eller byt ut det
Tilltäppning i utgångsröret Ta bort tilltäppningen
Fläkten suger inte
upp tillräckligt eller
vibrerar
Fel utgångsrör Kontakta installatören och följ
instruktionerna i denna
bruksanvisning
Lamporna är utbrända Byt ut lamporna
Lamporna tänds inte
Lösa lampor Skruva åt lamporna
SMEG. förbehåller sig rätten att göra ändringar för att förbättra sina produkter om de anser det
nödvändigt utan att detta försämrar produkten.
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Smeg kset 910 x bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Smeg kset 910 x in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 4,16 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info