7
Network Cable Connector
The Internet Camera’s rear panel features an RJ-45
connector for connections to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which should be
Category 5 twisted-pair cable). The port supports the
NWay protocol, allowing the Internet Camera to
automatically detect or negotiate the transmission speed
of the network.
Antenna connector (WL-400 only)
Screw on the antenna supplied with the WL-400 here.
DC Power Connector
The DC power input connector is located on the Internet
Camera’s rear panel, and is labeled DC 5V with a single
jack socket to supply power to the Internet Camera.
Power will be generated when the power supply is
connected to a wall outlet.
Reset Button
Reset will be initiated when the reset button is pressed
once, and Power LED begins to flash.
Factory Reset will be initiated when the reset button is
pressed continuously for three seconds or when Power
LED begins to light up. Release the reset button and the
Power LED will begin to flash, indicating the Internet
Camera is changing to factory reset. When factory reset
is completed, the Internet Camera will be set to default
on channel 11 and EES-ID is set as “NULL String” (This
default setting will let the Internet Camera connect to
ANY access point on the infrastructure network). The IP
