23336
134
Verklein
Vergroot
Pagina terug
1/322
Pagina verder
Simrad PI54
122
850-165186 / Rev.B
Sensor configuration
On delivery, all Catch sensors are configured in Channel 4 and
with Normal update rate. If you use more than one Catch sensor,
make sure that you set them up to operate on different channels
and with different sensor numbers!
Note: The sensor and the PI54 system setup must correspond,
otherwise the communication will not work.
To change the sensor setup (channel selection, update rate etc),
use the PI Configurator utility.
The Catch sensor can be configured (using the PI Configurator
software) to act as a FA701 catch sensor. This will allow the
sensor to be used with the Simrad FS trawl sonar. The
communication channel on the FS sonar must be set up to
correspond to the equivalent sensor number (1, 2, 3 or 4).
The sensor update rate controls how often the amount of fish
caught is measured and transmitted to the vessel. Three settings
are available. Note that a faster update rate will decrease the
battery life.
Fast (~5,3 sec): Recommended for trawling in areas where
the rate of filling is very high. Use this setting to avoid
damage to the trawl or excessive catches.
Normal (~33 sec): Recommended for normal fishing.
Slow (~125 sec): Recommended if maximum operational
battery life before charging is required. The system will be
more sensitive to bad communication conditions due to the
slow data update.
When the Catch sensor is configured as an FA701, it will
have a constant update rate of approximately 80 seconds.
This rate must not be changed.
System configuration
Sensor configuration: The sensor must be configured with a
unique sensor number. Select update rate and channel number
according to the sensors configuration. Write down this
configuration for future reference.
Status & Receiver: The Interference filter must be switched on.
Set it to level 9 if you have noise problems from other
hydroacoustic sources. Note that with the filter on, it will
influence the signal spectrum shown in the Status display.
Catch/Bottom sensor filter: Switch this filter off. Set it to
Light or Heavy only if you experience excessive noise.
134

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Simrad PI54 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Simrad PI54 in de taal/talen: Engels als bijlage per email.

De handleiding is 10,79 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Simrad PI54

Simrad PI54 Gebruiksaanwijzing - Norsk - 108 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info