670459
1
Verklein
Vergroot
Pagina terug
1/21
Pagina verder
CE1G2406E
SIGMAGYR
®
RVP
Installation and Commissioning RVP97...
1. Notes
1.1 Place of installation
In a dry space (e.g. the boiler room), on a control
panel or control panel rail, on the control panel fa-
cia or in the sloping front of a control desk.
The controller must not be exposed to dripping
water.
Permissible ambient temperature: 0...50 °C.
1.2 Electrical installation
The local standards and regulations for electrical instal-
lations must be observed.
Cable tension relief must be ensured.
The wires from the controller to the actuator and the
pumps carry mains voltage.
The wires from the controller to the detectors carry
protective low voltage.
The permissible cable lengths for all detectors are
the following:
Copper cable 0.6 mm dia. 20 m max.
Copper cable 1.0 mm
2
80 m max.
Copper cable 1.5 mm
2
120 m max.
The cables to the detectors should not be run paral-
lel to mains carrying cable (e.g. power supply for
the pumps).
2. Installation and wiring
2.1 Wall mounting
1. Separate base from the controller by loosening the
two fixing screws on the front of the controller
(Fig. 1).
2. Fit base to the wall (Fig. 2) or to a DIN mounting
rail (Fig. 3).
3. Wire base according to the plant wiring diagram.
4. Place the controller on the base and secure by
tightening the two fixing screws on the front of the
controller.
2.2 Flush panel mounting
1. Separate base from the controller by loosening the
two fixing screws on the front of the controller
(Fig. 1).
2. Remove terminal strips from the base (Fig. 4).
3. Wire the terminal strips. Make certain the cables
will be sufficiently long, allowing the control panel
door to be opened and the wired terminal strips to
be moved about.
4. Introduce terminal strips through the panel cutout
and plug them into the controller (Fig. 5). In that
case, the base will no longer be required.
5. Place controller in the panel cutout and secure
(Fig. 6).
Note
: tighten the fixing screws only slightly!
1
2
3
4
56
1

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Siemens-SIGMAGYR-RVP97

Zoeken resetten

  • wij hebben kastje voor vloerverwarming : Landis Gyr SQS35
    We willen de zekeringen controleren, waar zitten deze: welke soort kiezen om te vervangen
    De vloerverwarming doet het niet meer, maar geeft geen error aan Gesteld op 17-6-2020 om 13:23

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Siemens SIGMAGYR RVP97 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Siemens SIGMAGYR RVP97 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info