555848
4
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
CE2N2462E / 09.12.1998 Siemens Building Technologies
4/8 Landis & Staefa Division
In the case of flow temperature control with a mixing valve, d.h.w. heating is ensured
with a charging pump.
With boiler temperature control, the d.h.w. is heated either with a charging pump or
changeover valve. In the case of a charging pump, priority selection can be used:
Absolute priority: during d.h.w. heating, the heating circuit pump is locked
No priority (parallel): heating circuit pump and d.h.w. charging pump operate at the
same time
The temperature is measured with an immersion detector LG-Ni 1000
at 0 °C. If the
detector acquires a d.h.w. temperature below the setpoint, the charging pump or
changeover valve will be activated. The excess flow temperature during charging is
16 K (fixed value) above the adjusted d.h.w. temperature setpoint.
The d.h.w. storage tank is protected against frost. If there is risk of frost, the d.h.w. tem-
perature will not be allowed to fall below 5 °C.
The d.h.w. temperature can also be acquired by a thermostat. Charging takes place
when the thermostat's contact closes. There is no protection against frost.
Note: a relay controlled by the thermostat (low voltage!) must be connected to terminals
B3-M.
The heating circuit pump is activated to prevent freeze-ups in the plant. Frost protection
can be provided with or without an outside detector:
With outside detector:
Outside temperature
1.5 °C: the heating circuit pump will be switched on for 10
minutes at 6-hour intervals
Outside temperature
5 °C: the heating circuit pump runs continuously
Without outside detector:
Flow temperature
10 °C: the heating circuit pump will be switched on for
10 minutes at 6-hour intervals
Flow temperature
5 °C: the heating circuit pump runs continuously
Frost protection for the plant can be deactivated, if required.
Frost protection for the building acts as minimum room temperature limitation and pro-
tects the rooms from too low temperatures. It can be achieved with or without room unit,
provided the heating curve slope is correctly set.
Without room unit:
Attenuated outside temperature
5 °C: the control is switched on and the flow tem-
perature is controlled such that a room temperature of 5 °C will be maintained
Attenuated outside temperature >6 °C: the control is switched off
With room unit and with quick setback active:
Room temperature
5 °C: the control is switched on and the flow temperature is
controlled such that a room temperature of 5 °C will be maintained
Room temperature >6 °C: the control is switched off
With room unit, but without quick setback:
Same as without room unit
Frost protection for the building can be deactivated, if required.
Pump overrun: heating circuit pump and charging pump with six minutes overrun
Pump kick: all pumps are periodically switched on for one minute
When changing from the reduced temperature or standby mode to the normal tem-
perature, the room temperature setpoint is raised by 5 K. When the room temperature
reaches a level which lies 0.25 K below the setpoint of the normal temperature, boost
heating will be switched off.
Boost heating necessitates a room unit.
When changing from the normal temperature to the reduced temperature or standby
mode, the heating will be shut down until the respective room temperature setpoint is
reached.
Quick setback necessitates a room unit. This function can be deactivated, if required.
The ECO automatic energy saver controls the heating depending on demand. It
switches the heating off if permitted by outside temperature conditions while considering
D.h.w. heating
Frost protection for
the plant
Frost protection for
the building
Pump control
Boost heating
Quick setback
ECO automatic energy
saver
4

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Siemens-RVP200

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Siemens RVP200 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Siemens RVP200 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,76 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info