688542
8
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
EN-8
EN
Coffeemaker
SCE 3050SS / SCE 3051RD
Revision 05/2016
Copyright © 2016, Fast ČR, a.s.
OPERATING THE COFFEEMAKER
1. Open the lid A1 and fill the water tank A3 with the required amount of water. The water level
must at least cover the mark showing two water cups and must not go over the maximum mark
showing 10 water cups (i.e. 1.25 l).
Attention:
Only fill the water tank with cold drinking water. Do not use hot water.
The water tank has a maximum capacity of 1.25 litres of water.
The amount of brewed coffee will always be less than the amount of water you poured into
the water tank A3. During the coffee brewing process, approximately 10 % of the water is
absorbed by the ground coffee.
2. Place the permanent filter A7 or a disposable paper filter size no. 4 into the filter holder A8.
3. Pour ground coffee into the filter. Recommended dosage: 7 g of ground coffee per cup. Set the hot
water arm A2 so that it points above the filter.
Note:
If you wish to brew tea, pour the required amount of tea into the filter.
4. Shut the lid A1 and make sure that it is properly closed.
5. Place the glass kettle with the lid Aqs on to the hotplate Aqd and start the coffeemaker by setting
switch Aqf to position I (On). The red indicator light will be lit.
6. Once the entire batch of coffee has finished brewing, wait approximately 1 minute for the drip
process to complete fully. Now the coffee can be served.
7. If you wish to serve the coffee later, leave the kettle Aqs on the hotplate Aqd. The hotplate Aqd will
keep the coffee at an optimal serving temperature. The coffeemaker will automatically turn itself
off after 40 minutes of operation.
8. Once you empty the kettle, return it back on to the hotplate Aqd and turn off the coffeemaker by
setting switch Aqf to position 0 (Off). The red indicator light will turn off.
9. Allow the coffeemaker to cool down for at least 10 minutes before using it again.
Warning:
If you do not allow the coffeemaker to cool down, the water could overheat and result in
subsequent scalding by the escaping steam.
10. Before using the coffeemaker again, remove the coffee grounds and wash the permanent filter
A7 or remove the paper filter together with the coffee grounds and dispose of it together with
normal household waste. Rinse the filter holder A8 and the kettle Aqs with clean water. Dry it and
put it back in its place.
11. When not using the coffeemaker, turn it off and disconnect it from the power socket.
DRIP-STOP FUNCTION
The Drip-Stop function will allow you to serve coffee before the end of the drip process.
1. Once at least half the amount of coffee is brewed, you may remove the kettle Aqs from the
coffeemaker. The Drip-Stop shut-off valve will be activated and coffee will stop dripping.
2. Serve the required amount of coffee and place the kettle Aqs back on the hotplate Aqd within
approximately 1 minute of taking it off to avoid the filter from overfilling with hot water.
3. When the kettle Aqd is placed back under the brew chamber A9, the drip process will resume
automatically.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sencor SCE 3050SS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sencor SCE 3050SS in de taal/talen: Engels als bijlage per email.

De handleiding is 0,36 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info