699890
4
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
4 ASP-105 SATEL
4. Installation and start-up
The siren must be installed on the wall, high above the floor, at a hard to access location, so as to
minimize the risk of tampering. Make sure that some free space is left above the siren (at least 2.5
cm). Otherwise, it will be impossible to replace the cover.
1. Remove the cover locking screws.
2. Lift up the enclosure cover by approx. 60º and remove it (see Fig. 3).
3. Connect the battery to the dedicated leads (positive terminal to RED lead, negative terminal to
BLACK lead).
4. Add the siren to the wireless system (see the ABAX controller manual or the INTEGRA 128-WRL /
VERSA / VERSA Plus / VERSA IP control panel installer manual). The sticker with serial number
which shall be entered when registering the siren in the system can be found on the electronics
board.
5. Replace the siren cover.
6. Fasten the siren temporarily at the place of its future installation.
7. Check the level of signal received from the siren by the ACU-120 / ACU-270 controller or the
INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another place for
installation. Sometimes, it is sufficient to shift the device ten or twenty centimeters to obtain a
considerable improvement in the signal quality.
8. Remove the siren cover.
9. Disconnect the battery.
10. Move aside the catches holding the electronics board and remove it.
11. Place the enclosure base on the wall and mark the location of mounting holes (see Fig. 2). Be
sure to take into account the tamper mounting hole.
12. Drill the holes for wall plugs (screw anchors).
13. Run the power wires through the hole in the enclosure base (see Fig. 2).
14. Secure the enclosure base to the wall with wall plugs (screw anchors) and screws. Remember
about the tamper mounting hole. The wall plugs (screw anchors) and screws delivered with the
siren are intended for brick, concrete and similar mounting surfaces. For other surfaces (e.g.
drywall, wood, styrofoam), use other wall plugs (screw anchors), as required.
15. Secure the electronics board in the enclosure base.
16. Connect the battery to the dedicated leads.
17. Secure the power wires in screw terminals on the electronics board.
18. Replace the siren cover and fasten it with screws.
19. Configure the siren (e.g. define the maximum duration of acoustic signaling and the type of
acoustic signaling). For detailed information on how to configure the siren, refer to the controller /
control panel manual.
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 00
www.satel.eu
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Satel ASP-105 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Satel ASP-105 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Satel ASP-105

Satel ASP-105 Gebruiksaanwijzing - Nederlands - 4 pagina's

Satel ASP-105 Gebruiksaanwijzing - Deutsch - 4 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info