596978
2
Verklein
Vergroot
Pagina terug
1/3
Pagina verder
Charging the Battery
Charge your battery as soon as possible so you can
begin using your phone. Keeping track of your
battery’s charge is important. If your battery level
becomes too low, your phone automatically
turns off, and you will lose any information you
were just working on. For a quick check of your
battery level, glance at the battery charge indicator
located in the upper-right corner of your phone’s
display screen. If the battery charge is getting
too low, the battery icon ( ) appears and the
phone displays awarning message.
Using the Phone Charger
1. Plug the phone charger into an electrical outlet.
2. Open the micro-USB connector cover located
on the lower left side of your phone.
3. Plug the other end of the phone charger into the
micro USB connector.
A red indicator light means the battery
is charging.
A green indicator light means the
battery charging is complete.
The battery, can be recharged the before it
becomes completely run down.
Making and Answering Calls
Holding Your Phone
To maximize performance, do not obstruct the
internal antenna area. Also make sure you do not
cover the microphone with your hand while talking.
Making Phone Calls
Placing a normal phone call from your wireless
phone is as easy as making a call from any
landline phone. Enter the number, press TALK,
and you’re on your way to clear calls.
To make a call using your keypad:
1. Make sure your phone is on.
2. Enter a phone number from standby mode. (If
you make a mistake while dialing, press BACK to
erase the numbers.)
3. Press TALK.
4. Press END or close the phone when you arenished.
To place a call with the phone closed:
1. Make sure your phone is on and the Side Key
Guard feature is disabled.
2. Press and hold the volume on the right side of
the phone.
3. Follow the system prompts. (The call will be
made in speakerphone mode unless you have a
headset attached to the phone.)
•Say the name of your registered
Voice Dial entry.
You can also place calls from your phone by speed
dialing numbers from your Contacts and using
your History listings.
Answering Phone Calls
To answer an incoming call with the phone open:
1. Make sure your phone is on. (If your phone is off,
incoming calls go to voicemail.)
2. Press TALK to answer an incoming call.
(Depending on your settings, you may also answer
incoming calls by opening the phone or by pressing
any number key.)
To answer an incoming call with the phone closed:
1. Make sure your phone is on. (If your phone is off,
incoming calls go to voicemail.)
2. When your phone rings or vibrates, press the side
call key (volume) on the right side of the phone.
(The call will be answered in speakerphone mode.)
– or –
Open the phone to use the earpiece.
Your phone noties you of incoming calls in the
following ways:
The phone rings or vibrates.
The indicator light ashes.
The backlight illuminates.
The screen displays an incoming call message.
If the incoming call is from a number stored in your
Contacts, the entrys name is displayed. The callers
phone number may also be displayed, if available.
Turning Bluetooth On & Off
By default, your devices Bluetooth feature is
turned off. Turning Bluetooth on makes your phone
“discoverable”by other in-range Bluetooth devices.
To make your phone visible to other devices you
must also ensure that your phone’s visibility is not
set to Hidden.
The built-in Calendar offers several personal
information management features to help you
manage your busy lifestyle.
T9 Text Input lets you quickly type messages with
one keypress per letter.
Speed dial lets you dial phone numbers with one
keypressor two keypresses.
The built-in Bluetooth technology allows you to
connect wirelessly to a number of Bluetooth devices to
share information more easily than ever before.
Your phone allows you to run multiple applications
simultaneously.
Turning Your Phone On and Off
Turning Your Phone On
Press END
Once your phone is on, it may display “Looking for
service...,When your phone nds a signal, it
automatically enters standby mode the phone’s idle
state. At this point, you are ready to begin making and
receiving calls. If your phone is unable to nd a signal
afterve seconds of searching, a Power Save feature is
automatically activated. When a signal is found, your
phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also
initiate a search for service by pressing any key
(when your phone is turned on).
Turning Your Phone Off
Press and hold END for two seconds until you
see the powering down animation on the display
screen.Your screen remains blank while your
phone is off (unless the battery is charging).
Battery Capacity
Your phone is equipped with a Lithium Ion
(Li-Ion) battery. It allows you to recharge your
battery before it is fully drained. The battery
provides up to 4.9 hours of continuous digital
talk time. When there are approximately two
minutes of talk time left, the phone sounds an
audible alert and then turns off.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sanyo Pro 200 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sanyo Pro 200 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,94 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info