With the DVR, you can run both DVR and LCD modes.
If you connect the VGA connector of the PC to the rear port, the LCD feature will be enabled in LCD mode.
- You can configure the settings for each mode to your preference.
- If you want to switch the menu mode to set, press the [DVR] or [MONITOR] button on the remote control.
- Also you can switch the mode by pressing the [SOURCE] key on the front panel or remote control.
BEFORE START SETTING UP
Check the current mode.
Check if the VGA mode works properly.
When there is no connection at the VGA input, the On
Screen Display will show this message.
PICTURE
Active or inactive items may differ depending on the input source.
Mode
Press the [MENU] and [ENTER] button.
Press the [ENTER] or [►] button to select <Mode>.
Press the [ENTER] or [►] button to see the sub menu.
Press the [◄ ►] and [ENTER] button to select desired
value.
1.
2.
1.
2.
3.
4.
monitor setup
VGA
Check signal cable.
Move Enter
Return
Picture
Mode : Standard
Contrast 75
Brightness 55
Sharpness 50
Color 55
Tint G 50 R 50
Color Tone : Warm1
Backlight : 7
More
Dynamic
Standard
Movie
