483579
5
Verklein
Vergroot
Pagina terug
1/5
Pagina verder
54
The power steam and vertical steam functions (E 4) are
also possible if the steam control is set to . The interval
between bursts of steam should be about two seconds.
Important:
Never direct the steam at persons or animals!
E5 Spray function
To dampen stubborn creases, press the spray button.
Additional functions
F1 Anti-Drip system
Prevents water escaping from the soleplate when the
temperature is too low.
F2 Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale
deposits. This considerably prolongs the operational life
of your iron. The anti-scale cartridge is an integral part of
the water tank and need not be replaced.
Do not use descaling agents, as these damage the lining of
the steam chamber and so may impair the steam function.
F3 Automatic electronic 3-position cut-out (depending on
model)
If, although switched on, the appliance is not moved, it
will automatically switch off after the following intervals:
After 30 sec., if the iron is standing on the soleplate or
lying on its side.
After 8 mins., if the iron is standing on its heel.
The LED display starts to flash yellow-green-red in regular
sequence. If the appliance is moved, it will automatically
switch on again and begin to heat up again.
After ironing
• Unplug from the mains, pour away remaining water
and set steam control to . Then allow the appliance to
cool down.
• Store the iron standing on its heel.
• Do not wind the cord round the hot soleplate.
Cleaning and maintenance
When the appliance has cooled down, wipe it down with
a damp cloth or sponge, as required.
Dirt can be removed from the soleplate with a damp
cloth or sponge. Do not use sharp or abrasive cleaning
agents or objects.
Important: If the appliance has been standing unused for
long periods, hold it horizontal and allow it to emit
steam for approx. 1 minute to clean the steam ducts and
remove any residue from the iron.
G
H
F
Problems?
If you have any further problems or queries with our products
please call our Customer Relations team first for expert help and
advice:
HELPLINE:0845 602 1454 – UK, 01 4751947 – Ireland
If you are unable to trace the cause of the fault, contact an
official Rowenta Customer Service Centre. The addresses are
shown in the enclosed service centre address list. Further hints
and tips are obtainable from our homepage: www.rowenta.com.
In line with a policy of continuous product improvement
Rowenta reserves the right to change product specifications
without prior notice.
Problems
The iron is plug-
ged in, but the
soleplate of the
iron remains cold.
The soleplate is
not heating up
properly.
LED „Traffic Light“
display does not
light up.
None or too little
steam is being
emitted.
All 3 colours of
the Traffic Light
display flash
alternately.
The traffic Light
display flashes
red fast.
Brown streaks
come through the
holes in the sole-
plate and stain
the fabric.
The soleplate is
dirty or brown
and can stain the
linen.
The soleplate is
scratched or
damaged.
No mains supply.
The temperature
control is set too
low.
Temperature con-
trol set to "0".
There is insuffi-
cient water in the
water tank.
Anti-Drip is active
(F1).
The automatic cut-
out has activated:
the appliance is
on standby.
The temperature
sensor in the sole-
plate is defective.
You are using che-
mical descaling
agents.
You linen is not
rinsed sufficiently
or you have ironed
a new garment
before washing it.
You are using a too
high temperature.
You are using
starch.
You have placed
your iron flat on a
metallic rest-plate.
You have ironed
over a zip.
Check that the mains plug is
properly inserted or try
plugging the iron into a dif-
ferent socket.
Set the temperature control
to a higher temperature (D).
Turn the temperature control
to the required setting.
Fill the water tank (C).
Wait for the soleplate to reach
the correct temperature.
If moved, the appliance will
switch on again.
Call our Customer Relations
Helpline – see below
Do not add any descaling
agents to the water in the
water tank.
Ensure linen is rinsed
thoroughly to remove any
soap desposits or chemicals
on new garments which may
be sucked up by the iron.
See the temperature table to
correctly set the thermostat.
Clean the soleplate as indi-
cated above. Always spray
starch onto the reverse side
of the fabric to be ironed.
Always set the iron on its
heel.
Try to avoid ironing over zips
which may have rough edges.
Possible cause Solution
I
Innen - DX9200_7 08.04.2003 9:32 Uhr Seite 4
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Rowenta DX 9300 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Rowenta DX 9300 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,5 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info