With the supplied mounting plate you can install the appliance under, for example, a wall cupboard . For the
installation of the appliance proceed as follows:
Slide the mounting plate to the rear and remove the mounting plate.
Select a suitable installation location for the appliance ( see also the section Set-up location requirement).
Hold the mounting plate under the installation location. Thereby the front edge of the mounting plate
should be approx. 2.2cm behind the front of the cupboard so that, after the installation, the appliance is
flush with the cupboard.
Mark the 4 securing points with a pencil.
Using a spike or nail, make a small depression at the retaining lug into the respective depression on the
mounting plate.
Firmly screw the mounting plate on with the supplied screws(see illustration)
Place the appliance aslant, with the recesses in the top face of the appliance, in the mounting plate until
the appliance audibly locks into place.
Check to ensure that the appliance is securely seated.
Key List:
1. Power: Power on/Off
2. Open : Control of CD tray
3. UP | FF： Station tune up and forward of CD playback
4. DOWN|RW： Station tune down and backward of CD play back
5. Mode | Stop： Mode set and Stop of CD playback
6. MEM.Scan/AMS | Pause /Play： Preset Station review ,AMS, Play & Pause of CD play back
7. AL1/VOL-： Alarm 1 setup and Volume decrease
8. AL2/VOL+： Alarm 2 setup and Volume increase
9. Preset+ / Repeat： Call back preset station for up
10. Preset-： Call back preset station for down
11. Prog. /MEM： Station Memory
12. FUNC/user： CD、AUX、FM 、selector / user select
13. AOT/Dim： Automatic Off Timer and Dimmer control
14. Timer Opera for timer function
1 Start to Using the device
When unit is powered up first time, Automatic update function will start automatically and “PLEASE WAIT FOR
SETTING THANKS “is flashing on LCD, When press any key to terminate this function.
Note: When unit is powered up first time, Automatic update function will start automatically in 3~5
minutes. If the signal is received, time display on LCD accordingly
When the automatic system setting had been terminate by user, the date and clock are
defaulted to 01.01.2012 ,0:00.
