-5-
CAUTION: The stainless steel BLADE is very sharp. Never attempt to touch the
tip of the BLADE when operating, assembling, disassembling, or cleaning.
1. Make sure the unit is unplugged.
2. Unlock COVER by pressing the COVER RELEASE PUSH BUTTON
located on the back side of the unit. Lift to remove.
3. To remove DASHER, turn the UPPER HOUSING slightly clockwise
until it clicks. This will indicate that the gears are locked in place.
Unscrew DASHER by turning counter-clockwise.
4. Remove UPPER HOUSING by further turning clockwise and lifting.
5. Wipe down all parts and surfaces with a clean damp cloth.
CAUTION: Do not immerse unit in water.
To reassemble: Reverse the above procedure making sure that the UPPER
HOUSING is locked and aligned with the LOWER HOUSING.
Questions? Please contact us at www.rivalproducts.com
or at 1-800-557-4825.
HOW TO CLEAN YOUR SNOW CONE MAKER
-4-
1. Clean all components prior to first using
(See HOW TO CLEAN YOUR SNOW CONE MAKER).
2. Lift the POWER PUSH BUTTON LID and
place 4 - 6 ice cubes into the unit, leaving
about 1 inch from the top.
3. Place a wide-mouth cup under the ice chute
to catch the shaved ice.
4. Plug unit into electrical outlet.
5. Be sure that the top and bottom housings
are properly aligned. If the housings are
not aligned correctly the unit will not
activate.
NOTE: Never move the housing when in use.
6. Press the POWER PUSH BUTTON LID at the “PUSH” position to
start making shaved ice. Make sure your cup is under the chute.
7. Clean all excess ice/water from unit after use. (See HOW TO
CLEAN YOUR SNOW CONE MAKER).
NOTE: Occasionally ice may build up and will get lodged in the chute.
If ice is not coming out of the chute gently shake the unit to ensure
the ice is not frozen together.
CAUTION: Do not allow children to operate this appliance. The Ice
Shaver is for household use only. Do not attempt to sharpen the BLADE.
HOW TO USE YOUR SNOW CONE MAKER
