700360
9
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
ENG
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire
from the battery to avoid any risk of electric shocks and short circuits.
NOTE
8 9
ELECTRICAL INTERCONNECTION
BEFORE THE INTERCONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Ensure a
sufcient prole section (at least 10 mm
2
), a suitable fuse rating and a high conductivity of the cables when you purchase your
wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection.
Make sure that all screws are xed tight after the installation, because loosely connections may cause malfunctions, insufcient
power supply or interferences. We recommend therefore the RENEGADE REN10KIT wire kit.
FUSE
The inserted fuse protects the device against short circuits and overload. The standard fuse rating of 15 A must be
strictly adhered, when you replace a defective fuse.
BATT+
Connect the BATT+12V-terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a sufcient cross
section (at least 10 mm
2
) and install an additional in-line fuse. For safety reasons the distance between the fuse block and
the battery should be shorter than 30 cm. Do not set in the fuse into the fuse block until the installation is accomplished.
REM (TURN-ON SIGNAL)
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote wire of your head unit with the REM-terminal
of the sound system. Use a suitable cable with a sufcient cross section (0,5 mm
2
). Thereby the sound system will turn
on or off automatically with your head unit. If your head unit is not equipped with a remote wire, refer to page 10, section
#6. If you use the HIGH LEVEL INPUT like described there, you must not connect the turn-on signal under REM.
GND
Connect this GROUND terminal with a suitable contact ground point on the vehicle’s chassis. The ground wire must be
as short as possible and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground
point has a stable and safe electric connection to the negative “–”pole of the battery. Check this ground wire from the
battery to the ground point if possible and enforce it, if required. Use a ground wire with a sufcient cross section (at least
10 mm
2
) and the same size like the plus (+12V) power supply wire.
1 2 3 4
1
2
3
4
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Renegade RXV1000A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Renegade RXV1000A in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 0,77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info