700358
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
ENG
8
INTERCONNECTION
INSTALLATION
First connect the GND terminal ( 3 ) of the device to an appropriate ground connection at the chassis. To ensure a good connection, remove
dirt and dust from the connection point. A loose connection may cause malfunctions or interferences noise and distortion.
Use at least a 10 mm
2
cross-section for the power and ground connection cable. Suitable cable sets are available at the specialist shop.
Then connect the +12 V terminal ( 2 ) of the device with the battery by using an appropriate cable including an in-line fuse. This fuse
should be located very close to the battery; for safety reasons not more than 30 cm away. Only insert the fuse when the installation has
been accomplished.
Then connect the remote turn-on-wire from the head unit with the device‘s REM terminal ( 1 ). A cable with a cross-section of 0.5 mm
2
is
adequate.
Choose a suitable location for your device. The permanent temperature of the location should not be lower than 5°C and not higher than
50°C. Protect the device from moisture and humidity. Ensure that your device will not get loose during the drive and hurt someone in the
passenger cabin. Use therefor the included mounting brackets (4 x) and screws (8 x). Then use self-tapping screws (not included) from the
specialist trade, to fix the device in your vehicle.
Please observe not to damage any serial components of your vehicle (air bags, wires, gas tank etc.) during the installation of your device
by drilling or any other operations.
POWER SUPPLY AND TURN-ON-CONNECTION
The amplifier detects a voltage rise (6 Volts) with a so called ”DC Offset” over the connected input signal on the HIGH LEVEL input ( 5 ) when
the head unit will be switched on. Hence, the amplifier will also be turned on. As soon as the head unit will be turned off, the amplifier turns
also automatically off. In this case the turn-on connection at REM ( 1 ) is not needed, if the switch ( 6 ) is in position ON.
Note: The Auto Turn On-function ( 6 ) usually works with 90% of all head units, because they are equipped with ”High Power”-outputs. Only
with a few older and still existing head units the Auto Turn On-function is not working.
AUTO-TURN-ON FUNCTION
Fuse with a rating of 25 A ( 4 ). If the fuse is defective, please replace with an equivalent fuse.
FUSE
3 1
46 5 2
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Renegade RS1000A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Renegade RS1000A in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 1,01 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info