GB-3
• Mount the unit so that the control panel is plainly
visible for the driver.
• Do not leave it in direct sunlight for long periods of
time.
B. MOUNTING TYPES
We have provided 2 types of mounting methods.
• DASHBOARD MOUNTING (Illustration II)
The hook and loop fastener Velcro tape provided, may
be used to mount your detector on a flat dashboard.
The dashboard must be clean and dry for the fastener
to adhere properly.
• Remove backing from the “LOOP(fuzzy)” piece and
press firmly to the bottom of your unit.
• Clean dashboard with common rubbing alcohol to
remove dirt and grease.
• Peel the backing from the hook side and press the
unit into the desired position on the dashboard.
• WINDSHIELD MOUNTING (Illustration III)
• Insert the supplied suction cups and cushion into
each slot and windshield bracket.
• Slide the windshield bracket into the groove of the
detector.
• Use the Lock switch (LOCK) to lock the windshield
bracket.
• Locate the bracket on a clean windshield and press
firmly on each suction cup.
FOR BEST PERFORMANCE WINDSHIELD
MOUNTING IS RECOMMENDED!
C. POWER CONNECTION
The XT-7000 is designed to operate from the normal 12Volt
electrical system and must be used with a negative ground
electrical system. Do not operate your XT-7000 on positive
ground electrical system. Consult your vehicle owners’
manual if you are not certain of its polarity.
• After you position and mount the detector, insert the
DC power cable into the jack on the detector’s side.
• Remove the vehicle cigar lighter from its socket and
insert the other end of the power cable into the lighter
socket plug.
• For permanent installation, you will have to remove
the cigar lighter plug, take a 1A-fuse and connect the
cables directly.
m_Quintezz7000_GB_n.pmd 22.12.2005, 14:593
