The machine consists of an automatic
group to dispense coffee. The hydraulic
unit consists of a 1.5 liter capacity boiler
for dispensing coffee, hot water, and
steam.
The machine base and housing are
made of stainless steel.
The steam boiler is equipped with a
pressure relief valve calibrated at 2.5 bar
and a resettable hi-limit switch that
interrupts heating in the event of a fault.
The heat exchanger is equipped with an
expansion valve calibrated to 9 bars for
brewing espresso.
The coffee group heater is equipped with
an electronic temperature control and is
protected by a safety thermal fuse to
prevent overheating.
The pump is equipped with an automatic
resettable thermal protector in case of
overheating.
All heating elements subject to electric
current are situated inside the machine
housing.
Packaging materials such as (plastic
bags, expanded polystyrene, nails,
boxes etc.) are a potential hazard and
must not be left within reach of children.
Before plugging in the machine ensure
that the outlet voltage is 110Volts. A
resettable GFI outlet is recommended,
but not necessary.
The power cord should be fully extended
(avoid kinking or compressing) in a
position where it cannot be knocked or
tampered with by children; it should not
be placed near water or other liquids or
heat sources, it should not be damaged.
If necessary, have it replaced by a
qualified electrician.
The use of adaptors, multi-sockets or
extension cords is not recommended.
In case of doubt or uncertainty, have a
qualified electrician check the electrical
system, which should be in accordance
with local safety regulations in force,
including:
- The appliance must have an Earth
grounded outlet.
- Electrical wire sufficient for the power
rating.
- Efficient circuit breaker.
Place the machine on a water-repellant
surface (laminated, steel, ceramic etc.)
away from heat sources (ovens,
fireplaces etc.) and in an environment
where the tempture does not go below
40°F.
