698708
12
Verklein
Vergroot
Pagina terug
1/15
Pagina verder
ENGLISH
23
22
Ambient conditions
The remote control has a range of up to 6 m and works without any problems from
a radiating angle of up to 30° in relation to the front of the equipment. Dust on the
transmitter or dirt on the receiving sensor and operating it in the vicinity of fluores-
cent lights might reduce the range. A direct line-of-sight connection between the
transmitter and the receiver is needed.
Notes about the removal and the correct environmentally-friendly disposal of old
batteries
The symbol shown here can be found on the equipment‘s enclosure,
the packaging as well as in the documents or the operating manual.
It tells you that batteries provided with the equipment as well as those
supplied with or fitted in other units must never be disposed of in house-
hold waste. They must be disposed of in an environmentally-friendly
way (in compliance with the local regulations or European Directives 2002/96/EU
and 2006/66/EU).
You should find out where the nearest collection point for electronic scrap is or
where the recycling site is.
Correct disposal of the equipment and the batteries will help to preserve our
resources and prevent physical and environmental damage. The battery (CR2032)
supplied with the remote control contains lithium and it must be disposed of in an
environmentally-friendly way as described above.
Proceed as described in the following section to replace or remove the battery fit-
ted in the remote control.
1. Undo the screw in the cover underneath the remote control and then remove
the cover.
2. Remove the battery by sliding it out of its holder.
3. You must ensure that the new battery‘s polarity is correct when you fit the new
one! The side of the battery marked with (+) must point upwards so that it makes
contact with the part of the holder marked with (+).
4. Refit the cover and use the screw to secure it in place.
Installing
1. Ensure that the devices are switched off.
2. Connect the devices to the power supply using the accompanying power
cables.
3. Connect the device outputs of the P8 pre-amplifier with the inputs of the M8
power amplifier (ideally, you should use an XLR cable connection for this purpose)
(contact assignment of the XLR connection: Pin 1= ground; Pin 2 = plus / signal;
Pin 3 = minus)
4. You should now connect the source devices at your disposal. (Tuner, CD player,
PC, etc.)
5. If desired, connect the Link-Out socket of the P8 with the Link-In socket of the M8.
6. The speakers are connected using the back-mounted screw terminals depend-
ing on the desired operating mode (mono or stereo).
7. You must also ensure that the plus and minus connections on the amplifier concur
with the plus and minus connections on the speakers in order to prevent polarity
reversal.
Mono connection
(Left Channel)
On
Off
max. Power Consumption: 1,
2kW
Fuse:
100V / 115V:
T6.3 ,
A L250V
230V:
T3.15, A L250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
STROMSCHLAG GEFAHR
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATENCIÓN
RIESGO DE DESCARGA ELCTRICA
NO ABRIR
DO NOT REMOVE C OVER. N O USER
-
SERV ICEABLE PAR TS
IN SIDE. REFER SERVICING TO QUALIFIED PERSONN EL.
TO REDUCE THE RISK OF ELECTRICAL SHOCK OR FIRE, DO NOT
EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
In Out
Link
Gain
Mono / Stereo
RCA / XLR
+3 / 0
/
-10 dB
quadral GmbH & Co. KG - Am Herrenhäuser Bahnhof 26-28 - D-30419 Hannover
Handmade in Germany
®
AURUM
Balanced In
Right
Left
Mono In
Unbalanced In
Right
Left
Mono In
A
B
Right
+ +
Mono
AB
Left
+ +
Mono+
Fuse:
100V/115V: T250 mA L250V
230V: T125 mA L250V
~50/60 H z
max. Power Cons.: 10W
qua dra l GmbH & Co. KG - Am Herren h ä u ser Ba h n h of 2 6 -28 - D-30419 Hannover
On
Off
Out 2
L
R
Out 1
LR
Out 3
R
L
R
L
R
L
R
L
Aux
Tu ner
CD Ph ono L2 L1R2 R 1
Di rect
By pass
40
600
120
R/L 2
MCMMR/L 1
Ph ono S witches
XLR 2
LR
XLR 1
LR
Ph ono
GND
USB
TosLink
SP DI f
Digital In
Link
Out
Handmade in Germany
W ARNI N G :
TO REDUCE THE RISK
OF ELECTRICAL SHOCK
OR FIRE, DO NOT EXPOSE
THIS APPLIANCE TO
MOISTURE OR RAIN.
DO N OT REMO VE CO VER. NO USER
SERVICEABLE PA RTS I NSIDE. REFER
SERVICING T O QUA LIFIED PERSON NEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
+
Switch position XLR
and Mono at - 10dB
XLR left channel
On
Off
max. Power Consumption: 1,
2kW
Fuse:
100V / 115V:
T6.3,
A L250V
230V:
T3.15, A L250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ACHTUNG
STROMSCHLAG GEFAHR
NICHT ÖFFNEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATENCIÓN
RIESGO DE DESCARGA ELCTRICA
NO ABRIR
DO NOT REMOVE COVER. NO USER
-
SERVI CEABLE PARTS
INSIDE. REFER SER VICING TO QUALIFIED PERSO NNEL.
TO REDUCE THE RISK OF ELECTRICAL SHOCK OR FIRE, DO NOT
EXPOSE THIS APPLIANCE TO MOISTURE OR RAIN.
In Out
Link
Gain
Mono / Stereo
RCA / XLR
+3 / 0
/
-10 dB
quadral GmbH & Co. KG - Am Herrenuser Bahnhof 26-28 - D-30419 Hannover
Handmade in Germany
®
AURUM
Balanced In
Right
Left
Mono In
Unbalanced In
Right
Left
Mono In
A
B
Right
+ +
Mono
AB
Left
+ +
Mono+
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Quadral Aurum P8 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Quadral Aurum P8 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 1,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info